Bedienungsanleitung Epson SureColor SC-F2000 (Seite 5 von 104) (Englisch)

617671

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Introduction

Important Safety

Instructions

Read all of these instructions before using the printer.

Also be sure to follow all warnings and instructions

marked on the printer.

When choosing a place for this

product

❏ Place this product on a flat, stable surface that is

larger than this product. This product will not

operate properly if it is tilted or at an angle.

❏ Avoid places subject to rapid changes in

temperature and humidity. Also keep it away from

direct sunlight, strong light, or heat sources.

❏ Avoid places subject to shocks and vibrations.

❏ Keep this product away from dusty areas.

❏ Place this product near a wall outlet where the plug

can be easily unplugged.

When setting up this product

❏ Do not block or cover the openings in this product’s

cabinet.

❏ Do not insert objects through the slots. Take care

not to spill liquid on this product.

❏ This product’s power cord is for use with this

product only. Use with other equipment may result

in fire or electric shock.

❏ Connect all equipment to properly grounded

power outlets. Avoid using outlets on the same

circuit as copiers or air control systems that

regularly switch on and off.

❏ Avoid electrical outlets controlled by wall switches

or automatic timers.

❏ Keep the entire computer system away from

potential sources of electromagnetic interference,

such as loudspeakers or the base units of cordless

telephones.

❏ Use only the type of power source indicated on the

product’s label.

❏ Use only the power cord that comes with this

product. Use of another cord may result in fire or

electric shock.

❏ Do not use a damaged or frayed power cord.

❏ If you use an extension cord with this product,

make sure the total ampere rating of the devices

plugged into the extension cord does not exceed the

cord’s ampere rating. Also, make sure the total

ampere rating of all devices plugged into the wall

outlet does not exceed the wall outlet’s ampere

rating.

❏ Do not attempt to service this product yourself.

❏ Unplug this product and refer servicing to qualified

service personnel under the following conditions:

The power cord or plug is damaged; liquid has

entered the product; the product has been dropped

or the cabinet damaged; the product does not

operate normally or exhibits a distinct change in

performance.

❏ If you plan to use the printer in Germany, observe

the following:

To provide adequate short-circuit protection and

over-current protection for this printer, the

building installation must be protected by a 10 or 16

amp circuit breaker.

❏ If damage occurs to the plug, replace the cord set or

consult a qualified electrician. If there are fuses in

the plug, make sure you replace them with fuses of

the correct size and rating.

When using this product

❏ Do not touch the carriage scale.

❏ Do not put your hand inside this product or touch

the ink cartridges during printing.

SC-F2000 Series User’s Guide

Introduction

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson SureColor SC-F2000 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson SureColor SC-F2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info