571324
19
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
Instruction for use CALLISTO
19
© ETNA Coffee Technologies b.v.
COFFEE TECHNOLOGIES
Make sure the pump cup is properly in place. Incorrect
assembly may cause incorrect dosing of product.
7. Push the spout into the hose of the peristaltic pump.
8. Slide the hose lock off the hose of the BIB so that the hose is no
longer closed.
9. Switch the machine on at the on/off switch.
10.Place a jug under the dispensing nozzle.
11.Press button 3 on the service panel on the inside of the door. Keep
this button pressed until the hose of the peristaltic pump is
completely filled.
12.Press button 1 on the service panel on the inside of the door. The
mixer will be rinsed with hot water.
13.Repeat step 12 until the mixer is clean.
14.Close the cover and the door of the machine.
7.2.2.2 Cleaning the peristaltic pump for BIB with QCD connector
1. Open the door and lift the cover of the machine.
2. Switch the machine off at the on/off switch.
3. Open the QCD connector by pulling the inner part with the hose
connectors to the outside. The connector is fully opened when the
word “OUT” is visible on the inner part (see paragraph 5.4.2).
4. Detach the QCD connector from the pump hose.
5. Lower the clamp securing the pump cup.
6. Take the pump cup with hose out of the housing.
7. Clean the hose in the pump cup, the non-drip spout and the QCD
connector with hot water.
8. Clean the rotor assembly with a damp cloth.
9. Put the pump cup back in place.
10.Move the clamp over the pump cup.
Make sure the pump cup is properly in place. Incorrect
assembly may cause incorrect dosing of product.
11.Reconnect the QCD connector to the pump hose.
12.Slide the QCD connector on to the connector of the BIB.
13.Assemble the QCD connector by pushing in the inner section with
the hose connectors. The connector is fully home when the marker
on the hose connectors and the outer section of the QCD connector
are directly opposite one another .
14.Switch the machine on at the on/off switch.
Figure 7-2 Placing the pump cup on the peristaltic pump
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Etna CALLISTO wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info