Bedienungsanleitung Etna EEO131VA (Seite 54 von 57) (Deutsch, Englisch, Holländisch, Französisch)

482932

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

Instructions for Use

Maintenance and Cleaning

Automatic Defrosting of the

Refrigerator

The refrigerator requires no defrosting, since the

ice at the rear wall melts automatically. Ice,

formed at the rear end during the operation of the

compressor, melts when the compressor is off,

and water drops slide downwards through the

hole in the rear wall o the condenser collecting

receptacle, placed at the bottom of the appliance.

Manual Defrosting of the Frezing

Compartment

When the frost and ice layer in the frezing

compartment is 3-5 mm thick, you should clean

the freezer.

• Turn the thermostat knob to STOP (0) position,

and disconnect the power supply. Empty the

compartment and take care that the packages

remain frozen.

• Melted water, collected at the bottom of the

appliance, should be mopped with an absorbing

cloth.

• Avoid using defrosting sprays, as they may

cause damage to the plastic parts and may be

hazardous to health.

Cleaning the Appliance

Disconnect the power supply before cleaning

the appliance.

Do not use coarse or aggressive cleaning agents

as you can damage the surface.

Be careful to remove any cleanser agent

remaining after cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth

and an alcohol based cleaning agent (for

example glass cleaners). You may also use

alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially

aggressive cleaners, such as the stainless steel

cleaners, is not appropriate for the cleaning of

plastic and coated parts.

• Remove the detachable accesories in the

interior of the appliance and clean it with water

and liquid detergent. Plastic parts cannot be

washed in washing machine.

• Wash the interior of the appliance with

lukewarm water, in which you added one or two

spoonfuls of vinegar.

• The air openings in the bottom rail should be

cleaned or vacuumed periodically.

Cleaning of the condenser

Dust from the condenser should be

vacuumed in the following manner:

− push the finger through the opening in the

bottom rail and release the fastener;

− pull the rail towards you and remove it;

− remove the bottom board of the kitchen cabinet

− pull the condenser dish out;

− use the vacuum cleaner to clean the dust from

the condenser;

− replace the condenser dish and the bottom rail

in the opposite order.

After cleaning, connect the appliance to power

supply and reload the packages.

Periodical cleaning of the condenser

In order to optimize the operation of the

appliance and save energy, it is

recommended to clean periodically the dust

from the condenser at the back of the

appliance.

Disconnect the appliance from the mains prior the

commencement of cleaning!

• Empty the contents of the appliance.

• Remove the supporting panel from the bottom

of the kitchen cabinet.

• Remove the screws fixing the appliance to the

kitchen worktop.

• Pull the appliance out and expose the

condenser at the back of the appliance.

• Unscrew the screws from the condenser bonnet

and remove the bonnet.

• Clean the dust and dirt from the condenser.

After cleaning return the appliance to its place,

plug in the mains power cord and fill with food.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna EEO131VA Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info