Bedienungsanleitung Euroflex Monster SC35 PLUS (Seite 6 von 8) (Englisch)

500321

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

USING THE FLOOR BRUSH WITH THE CLOTH

Use a cotton cloth on the oor brush to absorb dirt and protect delicate surfaces. It can

also be used on vertical washable surfaces following the same procedure as the oor.

Put the cotton cloth under the oor brush and put the edges of the cloth under the

clamps. Once the cloth is too wet or too dirty, a clean cloth should replace the dirty

cloth. Old terry-cloth towels can be used or additional cloths can be purchased from

the retailer. If the oor surface is rough or textured, then use the bristles underneath

the oor brush to scrub the rough or textured oor. Then replace the cotton cloth to

absorb the loosened dirt.

CAUTION: The cloth will heat up. Take care when removing the cloth or replacing it

with a clean cloth.

IMPORTANT: When cleaning timber oors, parquetry, painted walls and ceilings and

other delicate surfaces make sure that the cotton cloth is securely attached to the

bottom of the oor brush and that none of the bristles break through. Please note

that bristles may break through thin cloths. If you don’t have a thick enough cloth,

please use 2 cloths.

ACCESSORIES

WINDOW CLEANER: This attachment is very useful for cleaning windows

and glass surfaces. Connect the window cleaner to the steam gun. Apply

steam abundantly, rub with the soft spongy edge then remove excess

water and dirt with the glass wiping edge (squeegee).

Wipe the squeegee with a cloth after every stroke.

CAUTION:

When cleaning windows, always avoid any sudden changes in temperature to

prevent glass breaking or cracking. Do not use on thin panes of glass or glass with

a thin wire mesh embedded in the glass.

DETAIL NOZZLE: This attachment is very useful for cleaning surfaces that

are difcult to reach. It is ideal for door and window tracks, shower door

tracks, wall grout in showers etc. The detail nozzle will t directly onto

the steam gun or it may be used with extension tubes.

DETAIL NYLON BRUSH: This brush is best used for cleaning grout found

in-between tiles or for any other surface that requires a bristle to do

light scrubbing. Push the detail brush onto the end of the detail nozzle.

PALETTE KNIFE: This attachement is best for removing small amounts of

wallpaper and for removing anything that can be scraped from a at

surface e.g. grease deposits in an oven. It is also useful when defrosting

freezers by scrapping away softened ice.

To use: Push the palette knife onto the end of the detail nozzle.

DETAIL BRASS BRUSH: This brush is best used for cleaning grease on oven

racks or grills and inside the enamel interior of ovens. To increase the

surface area of the brass brush, attach a small stainless steel scourer on

the brass brush to assist with removing baked on grease. Push the brass

brush onto the end of the detail nozzle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Euroflex Monster SC35 PLUS Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info