Bedienungsanleitung Eurom Force 2200IND (Seite 24 von 36) (Deutsch, Englisch, Holländisch, Französisch)

540700

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

USING CHEMICALS

This machine is fitted with an integrated chemicals tank. If you wish to add a cleaning agent to the jet

water, take the following actions:

 Remove the cap with the small hose from the tank

and fill this tank with cleaning agent. Replace the

cap and check that the end of the small hose is

hanging in the cleaning agent.

 Fit the normal jet lance onto the jet pistol (not the

cleaning head or terrace cleaner!) and adjust it to

the lowest pressure by pulling the nozzle forwards

(see diagram).

 When you use the jet the cleaning agent will now

automatically mix with the water and escape through the nozzle.

 Cleaning agents are not mixed in if you adjust the nozzle to the high pressure setting!

 Only use mild cleaning agents intended for high-pressure cleaners. No bleaches, chlorine, corrosive

substances or substances that contain acid. Dilute concentrated cleaning agents before pouring

them into the chemicals tank.

 If your skin comes into contact with the chemicals, wash them immediately and thoroughly with pure

water.

TIPS FOR USE

 When the water jet leaves the nozzle it causes the handle to recoil. You must therefore ensure that

you are standing in a stable position and have a firm grip. Also ensure that the high pressure of the

water jet does not cause objects to move out of place or fall or fly around and cause damage. Also

select a safe location for yourself!

 Keep your work environment clean and tidy.

 The high-pressure jet can cause damage to, for example, tyres if you move the jet too close. Always

maintain a minimum distance of 30 cm from the object to be cleaned! Always adjust the distance to

the object to be cleaned (and therefore the pressure) appropriately.

 Work from the bottom to the top in the case of vertical surfaces.

 Prevent water from splashing onto undesired places.

 Do not move the cleaner by pulling the electrical cable. Do not lift the machine up with the cable.

Prevent damage to the cable caused by oil, solvents, sharp edges, etc. Do not cover the machine

during use.

 Do not use the machine in an insufficiently ventilated room.

 It is forbidden to clean surfaces containing asbestos with high-pressure.

 If the machine is not used for longer than 5 minutes it must be switched off.

SWITCHING OFF

 Switch the machine off (Button to O).

 Close the water supply.

 Allow any pressure to escape by squeezing the trigger until no more water comes out of the nozzle.

 Close the safety lock on the handle.

 Pull the plug out of the socket.

STORAGE

 Before clearing the machine away, the water must be removed from the pump, the hose and the

accessories. You do this by switching the machine off with the switch and disconnecting the water

supply hose. Now start the machine again and squeeze the handle. Allow the machine to operate

until no more water comes out of the jet lance. Then switch the machine off immediately. Never allow

it to ’run dry’!

 Remove the plug from the socket, wind the hose up and hang the cable on the hook.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom Force 2200IND Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info