32
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Note: Attach the feet first before using the heater:
Turn the heater upside down. Place a blanket (or something similar) under the
heater to prevent damage!
Slide the feet from the side so that the grooves go as far as they can over the
protruding brackets; this will ensure that the threaded holes will align correctly.
Securely attach the feet to the heater using the short self-tapping screws.
Return the heater to the upright position.
Select a suitable location for the device taking into account all the
aforementioned wanings in this manual.
Check if the ON/OFF switch (D) is set to 'OFF' (O).
Fully extend the power cord and plug into a suitable 220-240V socket. Only
connect the heater to an earthed socket! To prevent the circuit overloading,
check that no other appliances are connected to the same group.
Set-up and operation
1. Output button
2. Celsius↔Fahrenheit button
3. Receiving point – remote control
4. Stand-by button
5. Ventilator button
6. Higher button
7. Lower button
8. Timer
Set the ON/OFF switch (D) to ‘ON’ (I). The display shows the current temperature
(left) and the set temperature (right) which is 25°C as standard. The device is now
in stand-by.
