500414
5
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
5
Uncertainty(K) 3dB
2. The operator to wear hearing protection
3.Vibration emission
Vibration total values(triaxial vector sum) determined
accordingtoEN60745
Chiselling
Hammermode
Vibrationemission
value(ah)
7.5m/s
Uncertainty(K)
1.5m/s
Hammer
drillingmode
Vibration emission
value(ah)
11m/s
Uncertainty(K)
1.5m/s
4.The following information
The declared vibration total value has been measured in
accordancewithastandardtestmethodgiveninEN60745
andmaybeusedforcomparingonetoolwithanother.
The declared vibration total value mayalsobeusedin a
preliminaryassessmentofexposure.
5.A warning
Thevibrationemissionduringactualuseofthepowertool
can differfromthe declared total value depending onthe
waysinwhichthetoolisused.
Identify additionalsafety measures toprotect the operator
thatarebased onan estimationof exposureintheactual
conditionsofuse(takingaccountofallpartsoftheoperating
cyclesuchas thetimes whenthetoolis switchedoffand
whenitisrunningidleinadditiontothetriggertime).
APPLICATIONS
•BoringintoConcrete
•Breakingupconcrete
•Makingholeforanchorbolt
•Consolidation,makinggroove,removal,etc.
[ExampleofUses]
Coolingandheatingwork,pipingandwiringwork,sanitary
arrangementswork,installationofmechanism,watersupply
anddrainagework,interiorwork,steelstructureinstallation,
othercivilengineeringequipmentrepairwork.
OPERATING INSTRUCTIONS
CHARGING THE BATTERY
1.Plugthechargerintothepoweroutlet.Within1second,
thechargingindicatorickerstwiceeachintheorderofgreen
redyellowandgointochargestandbymode.
2.Now,insertingthebatteryintothechargerwillimmediately
startcharging.
3. If work time of the battery is too short even after fully
charged,thebatterhastobereplacedimmediatelyasitslife
isended.
The batteries accompanying with the product as
purchasing or those not have been
used for a long time can be used again after recharging.
ATTENTION: Be careful not to make the terminals of the
battery short.
Short circuit of battery may cause re or explosion and
serious injuries may be resulted in.
CHARGING STATUS INDICATION (Fig.1.
ATTENTION: Be sure to use only specied battery and
charger.
If any other battery or charger than specied is used, re,
explosion, charging failure or overheat may be caused.
1.ChargingIndicator
Blinking green
Chargingstandby
Red On
Charginginprogress
Green On
Chargingcompleted
Blinking Red
Overheatstandby(Batterytoohot)
Blinking Yellow
Chargingnotavailable
ATTENTION: Be sure to unplug the charger power cord
after completing charging.
2.Ifchargingwithhotbatteryistriedimmediatelyafterbeing
just usedor charged,theindicator blinksinred (overheat
standby).
Coolingfanbuiltinthechargerautomaticallystartsrunning
tocoolthehotbatterydowntonormaltemperatureand,after
cooling, indicator is changed to red and normal charging
starts.
3.Thischarger detectselectricityof thebatteryto always
allowmakingfullcharging.
ATTACHING AND REMOVING BATTERY (Fig.2.
1.Attaching
• Set the forward/backward level in neutral position
(locked).
•Placethe chargedbattery fromunderthehandle of
productandpushittoitspositionuntilyouheartwoclicks.
2.Removing
•PressRight/Leftbuttonlocatedatthesideofbattery.
•Pullthebatterybackwardtoremoveit.
ATTENTION: Be sure to set the Forward/Backward lever
in neutral position when changing battery or tool, or
during transportation or storage.
BATTERY LEVEL INDICATOR (Fig.3.
Forcheckingbatterylevel,ONisdisplayed.
1=66~100%(LED3baron)
2=33~66%(LED2baron)
3=5~33%(LED1baron)
4=Lessthan5%(LED1barblinks)
LIGHTING FEATURE (Fig.4.
1.Itisconvenienttouselightingfeaturewhenworkingina
darkplace.
2.Pressingthelightbuttonwitharrowmarktoturnlighton
andpressingagainoff.
Light automatically turns off 1 minute after turning on.
ASSEMBLING SIDE HANDLE
AND ADJUSTING STOPPER
ATTENTION: In case an operation of drilling into concrete
and stone is carried out, be sure to attach the side handle
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Felisatti RH26 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info