Bedienungsanleitung Ferm CDM1119 (Seite 6 von 102) (Alle Sprachen)

632677

Zoom out

Zoom in

Vorherige Seite

1/102

Nächste Seite

Description

The numbers in the text refer to the diagrams on

pages 2 - 3

Fig. A

1. Machine

2. Battery

3. Battery unlock button

5. Charger

6. Charger LED indicator

7. Chuck

8. Gear selection switch

9. Direction switch

10. On / off switch

11. Torque adjustment ring

12. Work light

3. OPERATING

The battery must be charged before first

use.

Removing the battery from the machine

Fig. B1 + B2

 

the battery out of the machine like shown in

Fig. B1.

Inserting the battery into the machine

Fig. B1 + B2

Ensure that the exterior of the battery is

clean and dry before connecting to the

charger or machine.

 

machine as shown in Fig. B2.

 

into place.

Charging the battery (with the charger)

Fig. C

 

wait for a while. The LED indicator on the charger



LED indicator (6)

Fig. C



indicates the status of the charging process:

LED Charger status

Red Battery charging in progress

Green Battery charging finished, battery fully charged

 

to 72 minutes.

 

charger plug from the outlet and remove the

battery from the charger.

When the machine is not being used over

a longer period of time it is best to store

the battery in charged condition.

Fitting and removing drills or screwdriver bits

Fig. D

Always remove the battery before

mounting an accessory.



bits with round shaft as well as hexagonal shaft.

 

 

with your other hand in clockwise direction until

it is opened far enough for the bit to slide in.

 

 



 

activating the machine´s on/off switch.

Adjusting the gears

Fig. D

Never switch gears when the motor is

running, this will damage your machine.

Never put switch in the middle between both

positions, this will damage your machine.

The machine has 2 drill speeds, which can be





shows which position is chosen.

 

diameter or screw driving. The machine has

high power at a low speed.

 

diameter

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm CDM1119 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info