6 Ferm
Do not abuse cable
Never carry tool by the cable or pull it to disconnect it
from the power socket. Keep cable away from heat, oil
and sharp edges. Do not touch the metal plug pins when
connecting or removing the charger unit.
Secure work
Use clamps or a vice to hold work. It is safer than using
your hand and it frees both hands to operate the tool.
Do not over-reach
Keep a proper footing and balance at all times.
Disconnect tools from power supply
When not in use, before servicing and when changing
accessories such as blades, bits and cutters. Always
switch off and unplug the appliance from the
power supply when making adjustments.
Remove adjusting keys and wrenches
Ensure that they are removed from the tool before swit-
ching on.
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch.
Outdoor use
Do not use the charger unit outdoors. Do not expose
drill, or batteries to rain or damp conditions.
Connect a dust extraction device
Whenever there are facilities for fitting a dust extraction
system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury.
USING THE CORDLESS DRILL
BEFORE OPERATING
Check that:
- The voltage marked on the charger is suitable for use
with your mains supply.
- The output voltage on the charger is suitable to use
with the drill battery.
- The battery voltage is suitable for the drill.
The battery supplied with the drill is not fully char-
ged.
CHARGING THE BATTERY
- Place the battery charger on a level surface and put
the battery into the charger.
- Make sure the terminals on the battery tongue line up
with the + and – terminals on the charger.
- Put the pushpin connector into the charger and plug
the mains adaptor into the mains.
- Do not use a long extension lead with the charger.
Only use the charger between +10 and +40o C
- The red light on the charger indicates the battery is
being charged.
The first charge will take 5 hours, subsequent charges
take about 3 hours
The red light will not go out when the battery is fully
charged. Never charge the battery for more than 5
hours otherwise it will overheat.
Discharging the battery is as important as charging it. Use the
drill until it becomes less powerful and does not reach maxi-
mum speed, the battery is now ready to be recharged. Do not
discharge the battery completely – if this happens you will
damage the battery and it will not be able to be recharged.
If the drill is not going to be used for a long period recharge the
battery from time to time to prevent it running down. Store the
battery separately in the plastic case.
Do not use the battery charger to charge batteries other then
the one provided with drill.
Never open or incinerate a battery this can be dangerous and
will cause risk of explosion, pollution or other health hazards.
INSERT BATTERY
Place the battery in the end of the handgrip, it can only go
in one way and will click when in place. To remove bat-
tery, push the tabs in on either side of the battery with
finger and thumb and pull out of handgrip.
Ferm 3
AVAILABLE SPARE PARTS FOR FSD-1800K1
REF.NR. DESCRIPTION FERM NR.
2 KEYLESS CHUCK 406190
4 SWITCH 406189
7 BATTERY 406177
- CHARGER TSD-3L, 18 V 406178
- ADAPTOR TSD-1800L, 3 - 5 hr 406179
AVAILABLE SPARE PARTS FOR FSD-960K1
REF.NR. DESCRIPTION FERM NR.
2 KEYLESS CHUCK 406190
4 SWITCH 406189
7 BATTERY 406184
- CHARGER TSD-3L, 9.6 V 406178
- ADAPTOR TSD-960L, 3 - 5 hr 406196
