Bedienungsanleitung Ferm EHM1002 (Seite 6 von 32) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

632720

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

6 Ferm





Fig 1.

Note:

The fan will start as soon as the equipment is

switched on. The equipment will only heat up when

the room temperature falls below the temperature

set on the thermostat and the heat output switch is

on.

Switch on the required heating output (1). Turn the

control (2) to “max” until the required room

temperature has been reached. Then turn down the

control until you hear a clear click. The thermostat

will switch the heating element on and off

automatically.



In case of excessive heating, the heating function

shuts down automatically. The fan will restart. If this

occurs, turn off the equipment, disconnect the

mains plug and wait a few minutes for the

equipment to cool. After eliminating the cause (e.g.

a covered air grille), the equipment can be switched

on again.



After the hot equipment has been switched off (by

turning the heat output switch to “0”) the fan may

continue to run for a while to cool the equipment.

However, if the fan continues to run for more than

10 minutes, this is a sign that it cannot cut out

automatically because of the high room

temperature. In this case you must pull out the

power plug.



Cleaning

Keep the ventilation slots of the machine clean to

prevent overheating of the engine. Regularly clean

the machine housing with a soft cloth, preferably

after each use. Keep the ventilation slots free from

dust and dirt. If the dirt does not come off use a soft

cloth moistened with soapy water. Never use

solvents such as petrol, alcohol, ammonia water,

etc. These solvents may damage the plastic parts.



Store the equipment and accessories out of

children’s reach in a dark and dry place at above

freezing temperature. The ideal storage

temperature is between 5 and 30 °C. Store the

equipment in its original packaging.



Should a fault occur, e.g. after wear of a part,

please contact the service address on the warranty

card. In the back of this manual you will find an

exploded view showing the parts that can be

ordered.



To prevent damage during transport, the appliance

is delivered in a solid packaging which consists

largely of reusable material. Therefore please make

use of options for recycling the packaging.

Damaged and/or disposed of electrical or

electronic devices must be dropped off at

recycling stations intended for that

purpose.



For the conditions of warranty, please refer to the

separately provided warranty card. The product

and the user manual are subject to change.

Specifications can be changed without further

notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm EHM1002 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info