Bedienungsanleitung Ferm PDM1049P K (Seite 5 von 100) (Alle Sprachen)

763700

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

• Tighten the bit by turning the front sleeve (12)

counterclockwise while simultaneously holding

the rear sleeve (11) or turning it clockwise.

Setting depth stop

Fig. A

• Loosen the side handle (8) by turning it

counterclockwise.

• Insert the depth stop (3) through the hole in the

side handle ring.

• Slide the ruler to the desired depth.

• Retighten the screw firmly by turning it

clockwise

The On/Off switch

Fig. A

 



(5) the machine will turn off.

• The rotation-speed can be adjusted by



raising the rotation-speed or release pressure

for lowering the rotation-speed.

Lock-on Button

Fig. A

 



lock-on button (4).

• To release the switch-lock; shortly press the



Adjusting of the maximum rotation speed

Fig. A

 

switch (5).

 

lock-on button (4).

Switching the direction of rotation

Fig. A

Do not change the direction of rotation

during use.

• Direction of rotation counter-clockwise: shift

 ”.

 

 ”.

Function selection switch

Fig. A

In order to avoid damage to the machine,

adjusting the function selection switch (2)

shall only be done when machine is not

running

• Set the function selection switch (2) to (10) for

drilling.

• Set the function selection switch (2) to (9) for

hammer drilling.

User tips

Always use the machine with the side handle

firmly anchored in place - you will not only work

with more comfort, you will also work with more

precision.

Caution: drills and chisels can get very

hot.

Drilling and hammer drilling

• For large holes, for instance in very hard

concrete, start using a smaller bit for pilot

drilling first , then drill to nominal size.

• Hold the machine firmly with 2 hands. Be

aware the drill can jam and because of that

machine might suddenly turn (Especially when

drilling deep holes).

• Do not apply a lot of pressure on the machine,

let the machine do the work.

4. MAINTENANCE

Before cleaning and maintenance, always

switch off the machine and remove the

mains plug from the mains.

Clean the machine casings regularly with a soft

cloth, preferably after each use. Make sure that

the ventilation openings are free of dust and

dirt. Remove very persistent dirt using a soft

cloth moistened with soapsuds. Do not use any

solvents such as gasoline, alcohol, ammonia,

etc. Chemicals such as these will damage the

synthetic components.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm PDM1049P K Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info