Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
37
BEFORE USE
a. Before starting work, check the working area to avoid injury from obstacles such as
tree stumps, stones, tin cans or broken glass. Remove all obstacles before starting work.
(Terrain conditions, characteristics of the area, position of the obstacles, danger of the
surroundings)
b. When working with the equipment, a radius of 15 m is considered a danger zone
which must not be entered by anyone. If necessary, this danger area must be marked
with yellow warning tape or with warning signs. If two or more persons are working at
the same time, always ensure an adequate safety distance.
c. Start the Engine according to the instructions in the manual and make sure that the
cutters do not move when the Engine is idling.
DURING USE
a. Grip the handles firmly with both hands. When stopping work, first reset the throttle
to "start speed", then release the device.
b. When working, always ensure that the device is firmly balanced.
c. Always keep the Engine speed at the level required for cutting and never increase it
unnecessarily.
d. If you want to remove branches that have wrapped around the cutting edge, or if
you want to check the device or cutting edge, the Engine must first be stopped. Wait
until the cutting is completely stopped before carrying out such operations.
e. If the cutting edge has collided with hard objects such as stone, stop the Engine
immediately and then check the cutting edge. If the cutting edge is damaged, it must be
replaced immediately.
f. If work is interrupted by third parties, always switch off the Engine before turning.
g. To avoid electric shock, it is forbidden to touch the spark plug and cable when the
Engine is running.
h. Never touch the muffler, spark plug or other metal parts of the Engine while the
Engine is running or immediately after switching off the Engine. Doing so may cause
severe burns or electric shock.
i. If two or more persons are working at the same time, always maintain a sufficient
safety distance.
NOTES ON KICKBACK
Kickback of the device means that the device shakes heavily when the fast-moving
cutting edges collide with hard objects such as stone, concrete, wooden piles, etc. This
unexpected kickback can prevent the operator from operating the device properly. To
avoid this kickback, the following notes on kickback must be observed.
• Avoid colliding with hard objects, such as a pole, steel cable, rocks. This can
prevent damage to the cutting equipment.
• Please grip the handles firmly with both hands.
