26
Installation
The required installation dimensions can be found in
the installation instructions. Level the appliance with
the aid of the height-adjustable feet. Ensure that the
appliance is situated securely on the floor.
A built-under or integrated appliance which is
installed subsequently as a free-standing
appliance must be secured to prevent it from
overturning, e.g. by screwing it to the wall or by
installing it under a continuous worktop which is
screwed to adjacent cupboards.
The appliance can easily be installed in a fitted
kitchen between wooden and plastic walls. If the
plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3
mm must be fitted on the installation side to
satisfy the relevant safety instructions.
Waste-water connection
1 The required work sequence can be found in the
installation instructions. If required, fit a siphon
with an drainage connection.
2 Connect the waste-water hose to the drainage
connection of the siphon with the enclosed parts.
Ensure that the drainage hose is not kinked,
crushed or twisted and that there is no cover plate
in the drainage to prevent the waste water from
flowing out!
Fresh water connection
1 Connect the fresh-water connection to the tap
according to the installation instructions with the
enclosed parts.
Ensure that the fresh-water connection is not
kinked, crushed or twisted.
2 When replacing the appliance, always use a new
water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure: connect pressure-
reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water preferred; hot water max. temperature
60 °C.
Warm water connection *
* depending on model
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water:
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ‘:‹‹ is indicated on the digital
display 8.
To change the setting:
1 By pressing the 3 button, you can switch the
hot water setting off ‘:‹‹ or on ‘:‹‚.
2 Press START button )".
The set value is saved.
3 Close the door.
