584665
6
Zoom out
Zoom in
Vorherige Seite
1/10
Nächste Seite
Adjusting the cutting
mechanism:
e
w
q
e
9
r
9
w
ßq
The cutting gear of your cylinder mower was optimally adjusted
before leaving our company. If, after longer use,
a clean cut of the grass is no longer possible or the blade roller
contacts the lower blade, then the lower blade should be
adjusted as follows:
1. Clean the cylinder mower.
2. Lay the mower onto the ground, so that it cannot fall over
when adjusting the cutting mechanism.
3. Check cylinder
q
and lower blade
w
for notches and remove
these with a grindstone if necessary.
4. Unscrew the left and right hexagon screws
e
using a hexagon
wrench (10 mm) anticlockwise until the blade cylinder
q
can
only just turn freely.
5. Carefully tighten the left hexagon screw
e
using a hexagon
wrench (10 mm) whilst the blade cylinder
q
rotates, until it
lightly contacts the lower blade
w
.
6. Then unscrew the left hexagon screw again until the blade
cylinder just stops contacting the lower blade (rotates sound-
lessly).
7. Repeat the process on the right-hand side.
8. Cutting test:
Place a strip of paper
r
in such a way on the lower blade
w
that it points towards the spindle of the cylinder
q
.
9. Turn cylinder
q
carefully.
If the lower blade is set correctly
w
the paper will be cut off as
if with scissors.
10. Repeat the cutting test at different positions and on all blades
on the blade cylinder
q
.
Regrinding / repairs:
On safety grounds, only original GARDENA spares
may be used.
Please contact GARDENA Service if it is necessary to replace
the cutting tool, which will only become blunt after several years
use if well-maintained. Repairs to the cylinder mower and the
installation of the blades can be undertaken by suitable specialist
workshops.
Have the cylinder mower checked over in the autumn if possible
so that it is ready for use immediately when the next lawn-mowing
season starts.
For any other malfunctions please contact the GARDENA service
department.
8. Available accessories
GARDENA Grass Catcher Saves raking up the cut grass. Art. No. 4029
12
GB
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gardena 400 - 4018 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gardena 400 - 4018

Gardena 400 - 4018 Bedienungsanleitung - Deutsch - 10 seiten

Gardena 400 - 4018 Bedienungsanleitung - Holländisch - 10 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info