724639
13
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
26cc 2-Stroke Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
(toll free)
AFTER SALES SUPPORT
(toll free)
26cc 2-Stroke Hedge Trimmer
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
22 23
Maintenance Maintenance
Storage and Maintenance after use
1. Perform all the general maintenance recommended in the Maintenance
Section of your Instruction Manual.
2. Clean the outside surfaces of the hedge trimmer.
3. Check the fuel system for any leaks.
4. Drain the fuel from the fuel tank (12). Note. Do not discard unwanted fuel
with household waste. It must be taken to an authorised repository site.
NOTE. Draining the fuel tank should be done outdoors.
5. After the fuel is drained, start the engine.
6. Run the engine at idle until the unit stops. This will clear the carburettor
of fuel.
7. Allow the engine to cool (approx. 5 minutes).
8. Using the supplied spark plug spanner / combination screwdriver (23),
remove the spark plug (6).
9. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull
the recoil starter (8) slowly several times to coat the internal components.
Replace spark plug (6).
10. Store the unit in a cool, dry place away from any source of ignition such as
an oil burner, water heater, etc.
11. If disposing of the unit, recycle the unwanted materials instead of disposing
of them as waste. All tools, hoses and packaging should be sorted, taken to
the local recycling centre and disposed of in an environmentally safe way.
12. Check the operation of the on/o switch (10) controls prior to use or during
maintenance check. (refer to service centre if not operating correctly)
13. Check the condition of the blade for sharpness, cutting edge damage and
binding/ jamming of the blades prior to use or during maintenance check.
14. Check the clutch operation. With motor at idle, blades must not operate
and should only engage when motor is accelerated and stop when the
motor is slowed to idle prior to use or during maintenance check.
Removing a unit from storage
1. Remove spark plug (6).
2. Pull the recoil starter (8) briskly to clear excess oil
from the combustion chamber.
3. Clean and gap the spark plug (6) or install a new
spark plug with the proper gap. (Fig 9)
4. Prepare the unit for operation.
5. Fill the fuel tank (12) with the proper fuel / oil mixture.
See Preparation Section.
Service Support
If you have any issues with the operation of your product, please take it with a
copy of your receipt to one of our National Service Agents for repair.
A listing of our Service Agents is included with your product, however, you can
also nd our most updated listing by visiting https://help.tools/ and clicking on
the Service Agent link.
Accesories and After Sales Parts
Should you nd the spark plug or other consumables becomes worn
or past its user life, replacements can be purchased online via our
website https://help.tools/
If you have any queries regarding accessories, please call us on our
Customer Support Line - 1800 909 909.
2. Spark Plug
(Torch L9T)
2. Recoil Starter
(43671-SPRS)
3. Air Filter (43671-SPAF)
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gardenline MQE-3SPK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info