Bedienungsanleitung Garmin BarkLimiter Deluxe (Seite 3 von 8) (Englisch)

691419

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Introduction

WARNING

See the Important Safety and Product Information guide in the

product box for product warnings and other important

information.

Device Overviews

BarkLimiter Device

Contact points

Mode and intensity dial

Status LED

BarkLimiter Deluxe Device

Contact points

Mode and intensity dial

Status LED

Charging clip contacts (BarkLimiter Deluxe model only)

Attaching the Dog Collar Device to the Collar

Strap

With the buckle

facing outward, insert the end of the collar

strap through the slot

on the collar device.

Pull approximately two-thirds of the collar strap through the

slot.

Insert the end of the collar strap through the slot

on the

opposite side of the device.

Pull the strap until it is tight across the front of the device.

Charging the BarkLimiter Deluxe Device

NOTICE

To prevent corrosion, thoroughly dry the contacts on the collar

and the surrounding area before connecting the charging clip.

Before you put the collar on the dog, remove the charging clip. If

you do not remove the clip, it may become detached from the

collar and become lost.

You should fully charge the battery before you use the device

for the first time. Charging a fully depleted battery takes about

two hours. The device will not charge when outside the

temperature range of 32° to 104°F (0° to 40°C).

Snap the charging clip

onto the device.

Plug the small end of the power cable into the mini-USB port

on the charging clip.

Plug the other end of the power cable into a power source.

The status LED is solid red when the collar is charging.

After the status LED turns solid green, remove the charging

clip from the collar.

Turning On the Dog Collar Device

Rotate the dial away from N.

There is a 30-second delay before the device becomes active.

The status LED indicates the battery charge level for five

seconds and turns off. After an additional 25 seconds, the unit is

active. The status LED flashes occasionally to indicate that the

unit is detecting sound, motion, or vibration.

Turning Off the Dog Collar Device

Rotate the dial to N.

Rotating the Dial

NOTICE

Do not over-rotate the dial. The dial does not rotate past 7.

The dial is intentionally difficult to rotate. This helps to prevent

accidental rotation while the device is in use on the dog.

Insert a coin or similar object into the slot to rotate the dial.

Bark Correction

When the device is active and properly fitted on the dog, it

detects and corrects barks automatically. You can adjust the

method and intensity of the corrections.

The status LED flashes briefly when the device detects motion

or corrects a bark.

Short flash Motion was detected, and no correction was applied.

Long flash A bark was detected, and a correction was applied.

Introduction 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin BarkLimiter Deluxe Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin BarkLimiter Deluxe

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info