740402
3
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
2
Connect the red wire to the positive (+) battery terminal, and
connect the black wire to the negative (-) battery terminal.
3
If you have not already done so, connect the power cable to
the device by turning the locking ring clockwise.
Power Cable Extensions
Connecting the power cable directly to the battery is
recommended. If it is necessary to extend the cable, the
appropriate gauge of wire must be used for the length of the
extension.
Distance Wire Gauge
2 m (6.5 ft.) 16 AWG (1.31 mm²)
4 m (13 ft.) 14 AWG (2.08 mm²)
6 m (19 ft.) 12 AWG (3.31 mm²)
Connecting to a Device or to the Marine Network
You can connect the radar either directly to a radar-compatible
Garmin device or to a Garmin Marine Network to share radar
information with all connected devices.
NOTE: Not all Garmin devices are compatible with the Garmin
Marine Network. See the installation instructions or owner's
manual provided with your device for more information.
1
Route the network cable to your compatible Garmin device.
2
If you have not already done so, install the locking rings and
o-rings on the end of the network cable.
3
Select an option:
If the Garmin device is not compatible with the Garmin
Marine Network, connect the network cable to the port
labeled RADAR.
If the device is compatible with the Garmin Marine
Network, connect the network cable to the port labeled
NETWORK.
Radar Operation
All functions of this radar are controlled with your Garmin
chartplotter. See the Radar section of your chartplotter's owner's
manual for operating instructions. To download the latest
manual, go to support.garmin.com.
If you have more than one radar on your boat, you must be
viewing the radar screen for the radar you want to configure.
Measuring the Potential Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of
the radar scanner on a boat, if the radar scanner does not align
with the bow-stern axis.
1
Using a magnetic compass, take an optical bearing of a
stationary target located within viewable range.
2
Measure the target bearing on the radar.
3
If the bearing deviation is more than +/- 1°, set the front-of-
boat offset.
Setting the Front-of-Boat Offset
Before you can set the front-of-boat offset, you must measure
the potential front-of-boat offset.
The front-of-boat offset setting configured for use in one radar
mode is applied to every other radar mode and to the Radar
overlay.
1
From a Radar screen or the Radar overlay, select Menu >
Radar Setup > Installation > Front of Boat.
2
Select Up or Down to adjust the offset.
Specifications
Specification Measurement
Weight GMR Fantom 18 6.3 kg (13.8 lb.)
WeightGMR Fantom 24 7.7 kg (17 lb.)
Specification Measurement
Temperature range From -25 to 70°C (from -13 to
158°F)
Case material Thermoplastic resin
Maximum antenna rotation speed 48 RPM
Input voltage From 10 to 32 Vdc, 2.5 A max.
Power consumption
1
Standby: 3 W
Transmitting: 18.1 to 24.4 W
Fuse 7.5 A
Power output 40 W peak
RF transmit frequency 9335-9455 MHz nominal
Beam width GMR Fantom 18 5.2 degrees
Beam width GMR Fantom 24 3.7 degrees
Maximum range 48 nm
Minimum range 6 m (20 ft.)
Compass-safe distance 0.25 m (10 in.)
Minimum safe operating distance
2
100 W/m² = 0.08 m (3.15 in.)
50 W/m² = 0.12 m (4.72 in.)
10 W/m² = 0.26 m (10.24 in.)
Detailed Dimensions
Item GMR Fantom 18 GMR Fantom 24
Length 508.2 mm (20 in.) 645.4 mm (25
7
/
16
in.)
(width)
504.7 mm (19
7
/
8
in.) 642.5 mm (25
5
/
16
in.)
(height)
248.3 mm (9
3
/
4
in.) 250.3 mm (9
7
/
8
in.)
1
Power consumption when transmitting is affected by the range setting. A greater
range setting uses more power.
2
When it is transmitting, the radar should be located in a position on the vessel
that is at least this far from people. (IEC 60936-1, clause 3-27.1, specifies the
maximum distances from the antenna at which radio frequency (RF) levels can be
expected.)
These minimum safe distances apply for a transmitting radar with a rotating
antenna, and are much larger when the antenna is not rotating. If rotation of the
antenna is obstructed for any reason, the transmitter will automatically turn off.
3
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin GMR Fantom 24 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Garmin GMR Fantom 24

Garmin GMR Fantom 24 Installationsanweisung - Deutsch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info