691470
2
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
gWind
Installation Instructions
This wind transducer provides wind speed and wind angle
information to a NMEA 2000
®
network on your boat. A Garmin
®
GND
10 must be used to send data from this device to a NMEA
2000 network.
Important Safety Information
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
CAUTION
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
Use caution when working from heights.
Registering Your Device
Help us better support you by completing our online registration
today.
Go to http://my.garmin.com.
Keep the original sales receipt, or a photocopy, in a safe
place.
Installing the Propeller
1
Ensure the shaft
À
lines up correctly with the slot on the
propeller.
The socket on the propeller fits only one way on the shaft.
2
Press on the propeller until it is seated on the device.
3
Install the set screw
Á
to hold the propeller securely to the
device.
Mounting Considerations
When selecting a mounting location for the wind transducer,
observe these considerations.
The wind transducer should be mounted on a horizontal
surface on the mast head
À
.
If there is not a horizontal surface on the mast head, an
appropriate shim must be added to create a horizontal
surface.
The wind transducer should be installed facing the front of
the boat
Á
, parallel to the center line.
NOTE: If you do not mount the device facing the exact front
of the boat, or mount it facing the back of the boat, you must
configure the wind-angle offset to receive accurate wind-
angle data by following the directions in these installation
instructions.
Installing the Mounting Bracket
1
Using the mounting bracket as a template, mark the pilot hole
locations.
2
Using a 4.5 mm (
11
/
64
in.) bit, drill the pilot holes.
3
Fasten the mounting bracket to the surface using the
included screws.
Securing the Device in the Mounting Bracket
1
Loosen the lock nut
À
on the device by turning it counter-
clockwise by hand until it stops.
2
Place the device in the mounting bracket by pushing it down
Á
and sliding it back until it stops
Â
.
3
Secure the device in the bracket by turning the lock nut
clockwise by hand until it stops.
4
Attach the security clamp
Ã
to the device to prevent the lock
nut from loosening.
Connection Considerations
This device must connect to a Garmin GND 10 to communicate
with the NMEA 2000 network on your boat.
2 Installation Instructions
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin gWind wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info