691438
5
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
4
Mark new pilot-hole locations if necessary, and remove the
device from the mounting surface.
5
Drill the remaining pilot holes.
6
Secure the device to the mounting location.
Blink Codes
After the sonar module is installed, it turns on when the
chartplotter is turned on. The color status LED on the sonar
module indicates its operational status.
LED Color State Status
Green Blinking The sonar module is connected to a
chartplotter and is operating properly.
You should see sonar data on the
chartplotter.
Red Blinking The sonar module is turned on, but is
not connected to a chartplotter, or is
waiting to connect to a chartplotter. If the
sonar module is connected to the
chartplotter and this code persists,
check the wiring connections.
Orange Blinking A software update is in progress.
Red/Green Blinking Reserved
Red Two blinks
followed by a 3-
second pause
Other sonar failure.
Red Three blinks
followed by a 3-
second pause
The transducer is not detected by the
sonar module. If this code persists,
check the wiring connections.
Red Five blinks
followed by a 3-
second pause
The sonar module input voltage exceeds
the maximum input voltage.
Installation Diagram
Compatible Garmin chartplotter
Panoptix LiveScope GLS 10 sonar module
Garmin Marine Network small connector to full-size GarminMarine
Network adapter cable
RJ-45 connector
Garmin Marine Network cable small connector
7.5 A fast-acting fuse (required, not included)
NOTICE
You must connect the power wire through a 7.5 A fast-acting fuse
(not included). If you omit a fuse, the device can malfunction.
Power cable
Transducer cable
Panoptix LiveScope LVS32 transducer
Power Cable Extensions
If necessary, you can extend the power cable using the
appropriate wire gauge for the length of the extension.
Item Description
Fuse
Battery
9 ft. (2.7 m) no extension
Item Description
Splice
10 AWG (5.26 mm²) extension wire, up to 4.6 m (15 ft.)
8 AWG (8.36 mm²) extension wire, up to 7 m (23 ft.)
6 AWG (13.29 mm²) extension wire, up to 11 m (36 ft.)
Fuse
8 in. (20.3 cm)
Battery
8 in. (20.3 cm)
Maximum extension 36 ft. (11 m)
Calibrating the Compass
Before you can calibrate the compass, the transducer must be
installed on the shaft far enough away from the trolling motor to
avoid magnetic interference, and deployed in the water.
Calibration must be of sufficient quality to enable the internal
compass.
NOTE: To use the compass, you must mount the transducer on
the transom or the trolling motor shaft. The compass may not
work when you mount the transducer on the motor.
NOTE: For best results, you should use a heading sensor such
as the SteadyCast
heading sensor.
You can begin turning your boat before calibrating, but you must
fully rotate your boat 1.5 times during calibration.
1
From an applicable sonar view, select MENU > Sonar Setup
> Installation.
2
If necessary, select Use AHRS to turn on the AHRS sensor.
3
Select Calibrate Compass.
4
Follow the on-screen instructions.
Maintenance
Cleaning the Transducer
Aquatic fouling accumulates quickly and can reduce your
device's performance.
1
Remove the fouling with a soft cloth and mild detergent.
2
Wipe the device dry.
Specifications
Panoptix LiveScope LVS32 Specifications
Dimensions (L x H x W) 136.4 x 96.5 x 44.5 mm (5.37 x 3.8
x 1.75 in.)
Weight (transducer only) 850 g (1.87 lbs.)
Frequencies From 530 to 1.1 MHz
Operating temperature From 0 to 40°C (from 32 to 104°F)
5
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin Panoptix Livescope wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Garmin Panoptix Livescope

Garmin Panoptix Livescope Installationsanweisung - Deutsch - 6 seiten

Garmin Panoptix Livescope Installationsanweisung - Holländisch - 6 seiten

Garmin Panoptix Livescope Installationsanweisung - Französisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info