629089
3
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
Attaching the Base Plate to the Motorcycle Mount
NOTICE
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
À
through the
washers
Á
, cradle, spacers
Â
, and base plate
Ã
.
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
À
and the ball of the
base plate
Á
with the double-socket arm
Â
.
2
Insert the ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
6
Align the ball of the base plate attached to the cradle
Â
with
the other end of the double-socket arm.
7
Repeat steps 2–4.
Installing Your Device in the Motorcycle Mount
1
Fit the bottom of your device into the cradle.
2
Tilt the device back until it snaps into place.
NOTE: If the latch on top of the mount stays up after you
insert the device, press it down.
Removing Your Device from the Motorcycle
Mount
1
Press the button on the side of the mount.
2
Lift out the device.
3
On the motorcycle mount, place the weather cap on the
power connector in the center of the cable (Attaching the
Power Cables to the Motorcycle Mount).
Mounting Your Device in an Automobile
NOTICE
Before mounting the device, check the local laws pertaining to
windshield mounting.
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
1
Pull back the weather cap on the back of the cradle.
2
Plug the automotive power cable
À
into the mini-USB
connector
Á
under the weather cap.
3
Remove the clear plastic from the suction cup.
4
Clean and dry your windshield and the suction cup with a lint-
free cloth.
5
Press the suction cup
Â
to the windshield, and flip the lever
Ã
back toward the windshield.
6
Snap the cradle
Ä
onto the suction cup arm.
7
Fit the bottom of your device into the cradle.
8
Tilt the device back until it snaps into place.
TIP: Press on the logo at the top of the device while holding
the tab at the top of the cradle.
9
Plug the other end of the automotive power cable into a
power outlet.
3
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

garmin-zumo-390

Suche zurücksetzen

  • Karten auf Garmin Zümo gelöscht.
    Wie kann ich sie wieder herstellen? Eingereicht am 23-3-2022 21:17

    Antworten Frage melden
  • Mein Navi ist im Auto mit einem USB Anschluß verbunden zum laden. Sobald ich starte erlischt der Bildschirm und es kommt nur noch das Ladesymbol, ohne das man das Navi wieder hoch fahren kann.
    Sobald ich das Ladekabel vom Navi entferne kann man es auch wieder hoch fahren.
    Nehme ich das selbe Kabel, nur mit dem passenden Netzteil, fährt das Navi wieder hoch ?

    Warum ? Eingereicht am 31-8-2020 17:03

    Antworten Frage melden
  • Habe auf meinem Display oben rechts die Einblendung eines Fotoapperates. Was bedeutet das? Eingereicht am 8-5-2020 16:22

    Antworten Frage melden
  • im display zeigt touch dot,ich kann dabei das Gerät nicht mehr bedienen. Was kann ich tun ? Eingereicht am 30-4-2020 13:35

    Antworten Frage melden
  • Kann man auf ein zumo 390 andere Ansagesprachen installieren?
    Eingereicht am 8-3-2020 21:02

    Antworten Frage melden
  • Wie kann ich routen eingeben mit Zwischenzielen, ohne Straßennamen? Eingereicht am 30-4-2019 21:28

    Antworten Frage melden
  • Guten Tag,

    ich bekomme die Meldung " Datenspeicher voll" und es wird keine Route mehr angezeigt. Eingereicht am 10-6-2018 22:55

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin Zumo 390 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Garmin Zumo 390

Garmin Zumo 390 Bedienungsanleitung - Deutsch - 28 seiten

Garmin Zumo 390 Bedienungsanleitung - Englisch - 26 seiten

Garmin Zumo 390 Bedienungsanleitung - Holländisch - 26 seiten

Garmin Zumo 390 Bedienungsanleitung - Französisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info