714687
43
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
43
other liquid. Do not spill or drip any liquids on or in the motor unit or power cord to
avoid risk of fire and electric shock.
DO NOT clean the motor unit or power cord in an automatic dishwasher! Do not
use violence.
Glass container, lid, cutting assembly including the removable pairs of blades, lid
seal, and the non-slip silicone ring may be cleaned in an automatic dishwasher.
If possible, place these parts onto the top rack for cleaning. Ensure that the glass
container will not knock against other utensils during the cleaning cycle to avoid
damage.
In general, you should avoid leaving any food dry on the parts of the appliance
after processing.
DISASSEMBLING THE APPLIANCE
1. Always unplug the appliance after processing your food and before cleaning.
2. Remove the motor unit and lid.
3. You may remove the lid seal from the lid for cleaning. For this, carefully pull the
lid seal out of its groove.
WARNING - RISK OF INJURIES: Do not touch the blades of the cutting
assembly with your fingers to avoid injuries. For disassembling the cutting assembly,
always use the dedicated disassembling tool. Strictly observe the following instructions.
4. Grasp the upper plastic end of the blade shaft and pull the cutting assembly
out of the glass container, ensuring not to touch the blades with your hands. To
remove coarse residues of food, shortly rinse the cutting assembly under running
tap water.
5. If you had used the middle and/or upper pair of blades, you may remove these
pairs of blades for cleaning. Only the lower pair of blades is integrated in the
blade shaft. However, use special care, when handling any part of the cutting
assembly as the blades are very sharp. Place the disassembling tool onto a sta-
ble surface (table or counter). Insert the cutting assembly with the lower pair of
blades into the well of the disassembling tool. Hold the blade shaft tightly at the
upper plastic end. Then grasp the removable pair of blades at the fluted part of
its plastic body and turn it clockwise to unlock it. Pull the pair of blades upwards
to remove it from the cutting assembly. If required, repeat this procedure for the
other removable pair of blades.
43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gastroback 40961 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info