INSTRUCTIONS FOR ASSEMBLY AND USE
Tubular Drive Control
DC2-ECO - SL 433 MHz
The DC2-ECO is a modern and safe alternative to traditional Tubular
Drive key-switches that have to be hard wired.
To open or close a roller-shutter only the correct button on the hand
transmitter or the indoor keypad has to be pressed.
The most important characteristics of the DC2-ECO are:
➢ economic installation
➢ easy to use and programme
➢ water proof housings - IP 54
➢ A maximum of security through:
➢ transmission of a different unpredictable signal every time (Hopping Code)
➢ up to 100 million different coding possibilities
Technical Data:
240 V series
Supply voltage * 240 V AC 50 Hz 2,3 VA
Outputs 1 &. 2 1 x NO, NC relay contact,
isolated,10 A 250 V
Output 3 1 x NO, NC relay contact,
isolated, 5 A 250 V
Wiring 1.5 mm
2
max.,
Operating- -20 ˚C to +60 ˚C
temperature
* Further voltage variations upon request
geba GmbH is released its obligations regarding the guarantee and product liability if - with-
out prior permission - the unit has been modified, or if the installation is not in accordance
with our instruction manual.
The installer is responsible for adherence to the EMC- and low voltage regulations.
Caution!
Using the DC2-ECO with an industrial door, you must install the corresponding
security components, if the doorpanel weight is > 15kg. Electrical connections
may be carried out by skilled electrical personnel only.
Please note that all the keypad units are battery powered. The normal battery
life is dependent on the frequency of use of the appliance. For safety reasons
we advise replacement of the keypad batteries every 6 months.
16
GB
BA-DC2-ECO-GB 08.02.2002 16:27 Uhr Seite 1
