3
1. Insert a battery into the Receiver with corre
2. Switch off the re
initial use.
Place the receiver into the charging cradle of the transmitter
starttor will be red until the battery is fully
charged, once charged it will turn g
(See Below Fig. B)
3. Insert the spare battery into theshown below
fully charged, once chagreen . It should take approximately 3 hours.
(See Below Fig. C).
z A
z T
is detected for approx. 5 minutes o
When the signal
automatically turn ON again.
OPERA
Excessive volume can cause hearing damage!
z Prior to turni
increase the volume to requi
z Do not conti
1. Switch on the audio sound syst
connected to. The green LED Indicator will be on.
2. Switch the On/Off switch on the receiver to the ON positio
3. The neck-loop induction cable transmits the audio signal
directly to the hearing aid device in T-Mode '
Note: ● The hearing ai
proper opera
● Any earphone/headset must be take
the 3.5 mm audio output jack.
4. Earphone or headset can be connected to the 3.5 mm audio o
receiver for direct listening without he
5. Adjust the tone clarity setting for optimum performance.
Not
The receiver w
The Microphone Button
The microphone opening atreceiver picks up surrounding sounds.
When the microphone button is ON, you will hear the ambient soun
Press the microphone button to swit the microphone. The power-on indicator
will turn from green to red and two shot beeps will be heard. Ensure that the
microphone opening is not covered.
You can hear your surrothe receiver as an assi
device which helps you he
To switch the microphone OFF, pre
turn to green and you will be able to hear the soun
T
You can set the Tone Clarity by using the
key on the transmitter. Press and rel
the key repeatedly until you get the optimum
setting. The current setting will be indicated
by the status of the three LED's.
The above tabck which setting works best for you.
TROUBLESHOOTING
No Sound
• Ensure that the mains adapter is fully pushed into the power outlet and that the
cable is properly connecte
• Ensure that the Headset Power ON/.
• Check the state of the Battery charging in the Headset – place it in the Charge
Cradle and recharge the bathe Battery Charge LED turns green.
• Ensure that the TV set, Hi-Fi system or audio component is switch
to a channel that broadcasts an audio si
• Ensure that the volume on the connected audio component is turne
half its full volume.
• The connected audio
on the equipment.
• Use the Volume Control on the Headset to turn up the volume.
• Check whether the Headset volume level is set too low. Adjust the volume to a
suitable level.
• Try using a different connection RCA or
Distortion
• The battery inside the Headset may need chargin
• The Headset may be too far away from the transmitter inside the Charge Cradl
Bring them closer together.
• The audio signal input level is too
• The audio signal input level may be too high, lower the volum
source.
In the event that the neck loop receiv
transmitter
1. TOFF the power of the transmitter
2. TON the receiver
3. Press and hold the MIC Button for about 5 seconds, the Green LED will flash on
and off rapidlON the transmitter power
4. The receiv
LED on the receiver will show a consta
WA
The battery must not be exp
Do not attempt to replace the original recharge
When the headphones are n
damaging th
The battery must always be fully charged before first u
required to guarantee an acceptable service life for the rechargeable battery
ensure that the Receiver is FF position while
Excessive sound pressure from earphones and headphones can cause hearing loss.
IMPORT
This unit should be operated with re
battery or when disposing of the unit, always comply with appli
the disposal of batteries. Please place them in a proper dispos
ensure that they are eliminated safely and in an environment
TECHNICAL
Transmission : Digital Hopping System
Carrier frequency : 2.4GHz ISM BAND
Frequency response : 30 Hz – 10K Hz
Range : Up to 20 meters (open area)
Signal-to-noise ratio : >70 dB
Distortion :
Headset weight : 78 grams Transmitter Weight : 115 grams
Operating voltage : Transmitter : 5V, 550mA
: Headset: 3.7V, 350 mAh Lithium Polymer Battery
Operation time : Fully charged battery – up to 5 hours
Charging time : Empty battery – Approx. 3 hours
SAFETY
z
an integral on/off switch.
switch to OFF or unplu
z Keep away from heat sources such as hot-plates, and
z
z
z r is conne
power point and the AC-DC adapter.
For Users with a Pacemaker
If you have a pacemaker it is recommended that you speak with your
doctor or health advisor before u
GUARANTEE
From the moment your Geemarc product is purcha
the period of two years. Duri
discretion) are free of charge. Should y
help line or visit our website at www.
The guarantee does not cover accidentgence o
product must not be tampered with or taken apart by anyone who is not an au
Geemarc represent
The Geemarc guarantee in no way limit
IMPORTYOUR RECEIPT
RET
Please note: The guarantee applies to the United Kingdom onl
DECLARA
CE Directives
Geemarc Tthis product is in compliance with the
essential requirement
Tquipment Directive 2014/53/UE.
The CE declaration of conformity mwww
Electrical connection: The apparatus is des
supply only
apparatus does no
apparatus, disco
When inst
Recycling Directives
The WEEE (W put in place for
the productcled
When this product is finished with, please do not put it in your domesti
Please use one of the following disposal
- Remove the batteries and deposit them in an appropriate WEEE skip.
Deposit the product in an appropriate WEEE skip.
- Or If you purchase a new one, they should
accept it.
If you respect these instructions you ensure human
protection.
For product support and help visit our website at www.
Contact Ge
5B Swallow Court, Swallowfields, Welwyn Garden City
telephone 01707 38760
or fax 01707 832529
QUGCL7060 OPLOOP_En_A3_V1.0
Setting
Orange LED
Indicator Effect
Default Flat
B + T Bass Boost
+
Treble Boost
Treble Treble Boost
Bass Bass Boost
