Device Installation
1. Insert the TF card into the card slot with right direction.
2. Install the device on the wind shield or on the driving instrument board
with rack pad.
&Use clean and soft cloth to rub away the dirt and moisture on the wind shield or
instrument board.
3. Connect the USB port and Car Cigarette thru car charger.
4. Adjust the position for video-shooting.
&Press Mic Button or Rec button to make sure the position is right
6.Start the car, and the device will automatically power on and recording
Device Operation
*Automatic Video-Recording
1. Start the car engine
2. The device will be turned on and automatically recording;
The default recording is 2 minutes video file per section
3. To switch the normal/reverse phase of recording, Long Press "Mic" Button for 3
seconds to switch sensor positive shooting.
Long Press "Rec" Button for 3 seconds to switch sensor inverted shooting.
(The system will save the setting of normal/reverse phase switching)
4. Turn off the car engine;
5. The device will save the file and will be automatically power-off.
*Manual Video-Recording
1. After the device is powered on, press the Rec button for taking videos;
2. To switch the normal/reverse phase of recording, Long Press "Mic" Button for 3
seconds to switch sensor positive shooting.
Long Press "Rec" Button for 3 seconds to switch sensor inverted shooting.
(The system will save the setting of normal/reverse phase switching)
3. Press the Rec button again, and the device will automatically stop taking the
videos.
*Taking picture
1. Start the car engine
2. the device will automatically turn on and automatically record
3. In the video mode, short press camera/playback button to enter camera mode
4. short press camera/playback button again to take picture
5. press Rec button or switch button to return video recording mode
*Use motion detection recording function
1. When device is powered on, long press switch button to enable motion detection
function and there is “ ” icon show on screen
2. when motion detection function is enable, if the device senses moving objects4
around the scope, con on the LCD and REC indicator will
flash twice slowly, then the REC indicator goes off and device will in recording
mode
If the device doesn’t sense objects moving around the scope, the device will
automatically stop recording
3. Long press switch button, will disable motion detection function, and “ ” logo
will disappear on the LCD
*Use the Night Vision Mode
1. When the device is powered on, short press the “Turn on/off” Key to enable the
Night Vision function, the “ ” icon will be shown on screen
2. Short press the “Turn on/off” Key again to disable the Night Vision function.