Bedienungsanleitung Gigaset A120 - 2017 (Seite 12 von 16) (Englisch)

706750

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Lombok / Großbritannien - Irland / A31008-M2401-L101-2-7619 / Lombok.fm / 30.03.2017

Version 4, 16.09.2005

Specifications

Batteries

Technology: Nickel-metal-hydride (NiMH); Size: AAA (Micro, HR03); Voltage: 1.2 V;

Capacity: 400 - 1000 mAh

General specifications

Questions and answers

If you have any queries about the use of your telephone, visit our website at

www.gigaset.com/service

for 24-hour support. The table below contains a list of common pr

oblems and possible

solutions.

DECT standard is supported

GAP standard is supported

Range up to 300 m outdoors, up to 50 m indoors

Base station power supply 230 V ~/50 Hz

Radio frequency range 1880-1900 MHz

Transmission power 10 mW average power per channel, 250 mW

pul

se power

Environmental conditions

in operation

+5 °C to +45 °C, 20% to 75% relative humidity

Base station power consumption

A120/A220 A120A/A220A

In standby mode

– Handset in base station

– Handset outside base station

ca. 1.0 W ca. 1.2 W

ca. 0.8 W ca. 1.0 W

During a call ca. 1.0 W ca. 1.2 W

Problem Cause Solution

Nothing

pears in

the display.

The handset is not switched

on.

The batteries are flat.

Press the end call key a for approx.

5 seconds or place the handset in

the

base station.

Charge or replace the batteries.

No wireless

nnection

to the base

station,

Base flashes in

e display.

The handset is outside the

ran

ge of the base station.

The handset is not regis-

tered.

The base station is not

turn

ed on.

Move the handset closer to the base

sta

tion.

¢ page 9.

Check the mains connector on the

se station

¢ page 3.

Contact with liquid

If the handset has come into contact with liquid:

1 S

witch off the handset and remove the battery pack immediately.

2 Allow the liquid to drain from the handset.

3 Pat all parts dry, then place the handset with the battery compartment open and

the keypad faci

ng down in a dry, warm place for at least 72 hours (not in

a micro-

wave, oven etc.).

4 Do not switch on the handset again until it is completely dry.

When it has fully dried out, you will normally be able to use it again.

You cannot

hear a ringe

dialling tone

from the fixed

line network.

The phone cord supplied

has n

ot been used or has

been replaced by a new cord

with the wrong jack connec-

tions.

Please always use the phone cord

pplied or ensure that the

pin connections are correct when

urchasing from a retailer: 3-4

assignment of telephone leads/

EURO CTR37.

Error tone

sounds

after

system PIN

prompt.

PIN forgotten.

The system PIN you have

enter

ed is incorrect.

Reset the system PIN to the default

0000

¢ page 10.

All handsets are de-registered. All

ettings are reset. All lists are

deleted.

Problem Cause Solution

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gigaset A120 - 2017 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gigaset A120 - 2017

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info