Bedienungsanleitung Gira 118700 (Seite 5 von 11) (Englisch)

606987

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Teaching in radio motor valve drive

1. Start the programming mode on the radio motor valve drive by

pressing the red button for longer than 4 seconds.

✓ The top red LED flashes: The radio motor valve drive is now in the

programming mode for approx. 1 minute.

2. Trigger the teach-in telegram on the corresponding radio transmitter

(radio room temperature sensor or radio controller).

See operating instructions of radio transmitter.

✓ The radio motor valve drive acknowledges the teach signal and the

storage of the radio connection by the top LED lighting up

continuously.

3. The programming mode ends automatically after approx. 1 minute or

by briefly pressing the red button.

Radio motor valve drive is outside teach-in range

If the radio motor valve drive is mounted outside the teach-in range

(approx. 5 m), proceed as follows with for teaching in:

1. Insert the batteries before the radio motor valve drive is mounted on

the heating valve.

✓ All LEDs light up briefly. Then the radio motor valve drive carries out

the traverse motions (calibration traverse).

2. Position the radio motor valve drive near the corresponding radio

transmitter and teach it in.

3. Remove the batteries from the radio motor valve drive (the taught-in

radio connection is retained).

4. Mount the radio motor valve drive on the heating valve.

5. After approx. 1 minute, insert the batteries in the radio motor valve

drive again.

✓ All LEDs light up briefly. Then the calibration traverse begins

automatically.

✓ With this procedure, the temperature control may be carried out

delayed, as the radio motor valve drive requires some time following a

battery change to synchronise with the radio transmitter.

Limited radio range

In the programming mode, the radio range of the radio motor valve drive

is limited to approx. 5 m.

Teaching in several radio motor valve drives

If several radio motor valve drives are to be assigned, first all valve drives

must be switched into the teach-in mode before that teach-in process is

started on the radio transmitter.

If a radio motor valve drive is to be assigned to a group at a later time,

first all radio connections must be deleted in order to then assign all radio

motor valve drives simultaneously.

Assigning new radio transmitter

When teaching in a new radio transmitter, the existing assignment is

overwritten. In this case, the radio motor valve drive reacts to the radio

transmitter assigned last.

Calibration traverse must be carried out

If the calibration traverse is not carried out again, please remove the

batteries again and reinsert them after approx. 1 minute.

If the radio motor valve drive is not calibrated to the heating valve, no

correct temperature control can take place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gira 118700 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gira 118700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info