Bedienungsanleitung Gorenje ecd 620 ex (Seite 11 von 12) (Englisch)

336808

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

233036

‘’ The appliances are suitable for photovoltaic electrical power

under the condition that electrical voltage will be 220VAC

- 240VAC with semi tonic frequency 50Ηz in order the appliance

to operate properly (alternative a generator can be used with the

same technical characteristic).’’

The cooking hob should be earthed by a ring of the yellow-green

earthing wire that is factory-ﬁ tted on the built-in hob. Attach

the cable shoe of the earthing wire to the earthing clip on the

oven frame using a star washer and a nut. The earthing clip is

indicated by the earthing symbol

1 - Connector plugs

2 - Connector plugs

3 - Green-yellow earthing wire with a cable shoe

Ground connection of

the built-in cooking hob

Ground connection of

the built-in cooking hob

• The appliance may only be connected by an authorized skilled technician.

• Electric system protection should comply with all relevant regulations.

• The connection clips can be accessed when the connection clip covers are opened / removed.

• Before connecting the appliance, make sure the voltage indicated on the rating plate is

consistent with the voltage in your home circuit.

• The rating plate with basic information is attached on the lower side of the hob.

• The electric circuit should also include an omnipolar switch that will separate the appliance from

the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include

fuses, current protection switches, etc.

• The connection should be selected according to the installation possibilities with regard to

current and fuses.

• Given the protection from the risk of ﬁ re, appliances of this type may be installed in a worktop

next to a piece of kitchen furniture that is taller than the appliance (when installed); however, in

this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,

adjacent to the appliance.

• The current conducting and isolated parts must be protected from any possibility of direct contact.

WARNING!

Before any intervention, disconnect the appliance from the power mains. Connect the built-

in cooking hob to the kitchen range using two connector plugs. The plugs are installed on the

hotplate or cooking zone leads, while the corresponding sockets are attached to the oven frame,

behind the switchboard. Connect the two parts of the kitchen range by inserting the plugs into the

corresponding connector sockets without using any tools.

Important: the design of the connector plugs allows them to be connected in one way only.

Therefore, make sure to ﬁ nd the right, i.e. matching pair of connectors (the plug should slide into

the socket with a click, when pressed lightly). If, by mistake, you attempt to connect a pair of non-

matching connectors, their respective designs will mechanically prevent you from doing so. In such

case, try connecting the plug to the following socket.

Connecting the appliance to the power mains

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje ecd 620 ex Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info