Bedienungsanleitung Gorenje gns 64 e inox (Seite 9 von 11) (Englisch)

334147

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Instructions for Use, Building- in and Connecting

Connecting the cooktop to the gas supply

Safety precautions

• The appliance must be connected in

accordance with the standing ragulations, and it

may be used only in well ventilated rooms.

Before any attempt to connect the appliance

read carefully the instructions!

• Before installation and connection check if the

local connection specifications (type and

pressure of gas) correspond to the

specifications of the appliance.

• The technical specifications of the appliance

are indicated upon the rating plate.

• The appliance is not suitable for connection to

the vapour release channel (chimney). The

appliance must be installed and connected in

accordance with the standing regulations.

Special attention must be paid to the particular

ventilation requirements.

Provision for ventilation

The room containing the cooker should have an

air supply in accordance with BS5440: Part 2.

The room must have an opening window or

equivalent; some rooms may also require a

permanent vent. If the room has a volume

between 5 and 10 m

, it will require an air vent of

50 cm

effective area unless it has a door which

opens directly outside. If the room has a volume

of less than 5 m

, it will require an air vent of 100

effective area. If there are other fuel burning

appliances in the same room, BS 5440: Part 2

should be consulted to determine air vent

requirements.

Liquid gas connection

1 Connection extension with conical exterior

thread ISO 7-1 R ½ , wrench 22

2 Coil with interior thread ISO 7-1 Rp ½

3 Gas connection pipe

Connections

• Bottom side of the cooking hob is fitted with gas

connection with exterior thread ISO 7-1 R ½.

Some appliances are provided with a coil with

interior thread ISO 7-1Rp ½.

• During the installation the gas connection R ½

should be gripped tight to prevent twisting.

• Use gaskets for connection sealing.

• The temperature of the cooking hob bottom

exceeds the ambient temperature for 70 K. The

temperature of the ceiling and rear wall of the

oven built-in below the cooker may exceed the

ambient temperature for 70 K.

• Connect the appliance to the gas supply by

means of approved hose.

• If the built-in oven is located under the cooking

hob, the gas supply pipe must either be flexible

and made of stainless steel (interior and

exterior pipe), or rigid and made of copper or

steel.

• The connection for the cooking hob built-in

independently may be non-metal flexible pipe,

but it must never touch the bottom of the

cooking hob.

• Connection of pipe with the appliance joint must

not be submitted to torsion or any applied

pressure. This should be taken care of when

lowering the hob from upright position.; it is

important to select the most appropriate

sequence of installing connection pipe.

• The hose may not touch the mobile parts of the

kitchen elements (f.e. the drawers) and should

move freely.

• Connect the appliance in accordance with the

regulations of the local gas supplier.

• Important! Check all the connections for

tightness after the installation!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje gns 64 e inox Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info