590622
32
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
32 GMC-I Messtechnik GMBH
Inspecting the Integrated Fuse F2
The fuse F2 is located in the battery supply path. If the LC
display is not active upon switching the instrument on:
check whether the batteries have been inserted with
the polarity symbols at the correct end.
If the LCD remains inactive it might be defective.
Replacing the Fuses
Fuse F1 for the m/measuring ranges and fuse F2 for
the battery power supply are both firmly soldered in. They
are not intended to be replaced by the user.
If one of the fuses is defective, you are requested to send
the instrument to our repair service or to the respective
subsidiary abroad (the address is given in chapter 12).
This provides you with the guarantee that type-tested and/or
Ex-approved fuses with the correct triggering characteristics,
nominal current and breaking capacity are inserted. Addition-
ally, the instrument will be subjected to a safety test.
Instructions for the service
Warning!
Ex Environment: Remove the instrument from the
potentially explosive environment before opening.
Attention!
!
Non-Ex Environment: Disconnect the instrument
from the measuring circuit before opening to re-
place batteries!
Open the instrument in the same manner as for replac-
ing the batteries.
Warning!
Use the specified type-tested fuses only!
If fuses with other blowing characteristics, other
current ratings or other breaking capacities are
used, the operator is placed in danger, and pro-
tective diodes, resistors and other components
may be damaged.
The use of repaired fuses and short-circuiting the
fuse holder are prohibited.
10.3 Housing and Display
No special maintenance is required for the housing. Keep out-
side surfaces clean. Use a cloth slightly dampened with water
for cleaning.
Attention ! Do not under any circumstances use cleansers, abrasi-
ves and solvents !
This particularly applies to the display surface to avoid
damaging the high-quality explosion protection coating,
thus reducing its efficiency.
32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gossen Metrawatt METRAHIT 27EX wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info