Bedienungsanleitung Greenworks G24AC (Seite 7 von 147) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Finnisch)

708284

Zoom out

Zoom in

Vorherige Seite

1/147

Nächste Seite

English

4. Do not use force when inserting the battery pack. It

should slide into position and “click”.(sold separately)

To remove (See Figure 2.)

1. Press the latch button (1) on the battery pack down and

hold.(sold separately)

pack out of the housing.(sold separately)

snugly in order to prevent accidental

dislodging. It may require a strong pull to

remove it.(sold separately)

WARNING

• Replace the battery pack or the charger immediately

if the battery case or charger cord is damaged.(sold

separately)

• Verify that the switch is in the OFF position before

inserting or removing the battery pack.(sold separately)

• Verify that the battery pack is removed and the switch

is in the OFF position before inspecting, adjusting, or

performing maintenance on any part of the blower.

•Read, understand, and follow the instructions contained

in the section entitled Charging Procedure.

•If a leak develops ,the released electrolytes are

corrosive and toxic. DO NOT get the solution in the eyes

or on skin ,and do not swallow it.

DO NOT place these batteries in your regular household

trash. The battery must be removed from the appliance

before it is scrapped.

STARTUP

1.Before each startup,make sure the power switch is in the OFF

position

3.Release pressure from the system. Drain moisture from the

air tank by slowly opening the air tank drain valve by turning

counterclockwise. Once all the moisture has drained out, close

the fitting securely.

NOTE: Air tank will not pressurize while drain valve is

open.

4.Turn the pressure regulator knob fully counterclockwise to

5.Attach air hose and accessories.

WARNING

Too much air pressure causes a hazardous risk

of bursting. Check the manufacturer’s maximum

pressure rating for air tools and accessories.The

regulator outlet pressure must never exceed the

maximum pressure rating.

6.Insert the battery pack to the air compressor securely. (sold

separately)

7.Turn the compressor ON by moving the switch to the AUTO/

ON position and allow the tank pressure to build.Once the

air pressure reaches the maximum preset pressure(“cut-out

“pressure) it will automatically shut off.

8.Slowly turn the pressure regulator knob clockwise to open

reached.

NOTE: The air compressor will automatically restart once

the pressure in the air tank drops below the minimum

preset pressure ( "cut-in" pressure).

DANGER

Do not disassemble check valve, tank drain valves or

safety relief valve with air in tank — bleed tank. Failure

to depressurize tank could result in explosion and/or

serious personal injury.

WARNING

Always wear eye protection with side shields. Failure to

do so could result in objects being thrown into your eyes

and other possible serious injuries.

Fig. 4

OPEN

AIR TANK

PRESSURE GAUGE

TOOL OUTLET

PRESSURE GAUGE

Fig. 5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Greenworks G24AC Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info