Tuning to a station
There are three possibilities for tuning in to a station:
– Automatically - the stations are sought automatically.
– Manually - This is easy if the frequency of the station is
already known (e.g. from your radio and television guide).
– Directly - The easiest way to obtain a station if its frequency
is already known.
Automatic tuning
• Keep 3 or 4 (
TUNING UP
or DOWN) pressed down until the
frequency on the display changes continuously. Tuning will
stop automatically as soon as a station is found.
• Repeat this until you have found the desired station.
Manual tuning
• Keep 3 or 4 pressed down until you come close to the
desired frequency.
• Then briefly press the other button (3/4); tuning will stop.
• Then press 3 or 4 repeatedly until you reach the desired
frequency.
Direct selection
• When POWER is switched ON, press FREQ..
– The frequency disappears from the display.
•
You can now enter the station’s frequency with the 1…0 keys.
• Confirm the entry by pressing FREQ. once more.
– If you insert an invalid frequency, the display shows ‘Err’.
• Repeat the steps above, making sure the frequency is
correct.
Preset radio stations
You can programme 20 stations into the memory, 5 on each
waveband.
Programming
• Press POWER button to switch on the radio.
• Tune to a radio station automatically, manually or directly.
• Press the MEMO/TIME SET button. The ‘MEMO’ sign starts
flashing on the display.
• Press the preset button (1…5) to store the selected station.
• Press MEMO/TIME SET button again to complete the storing
procedure.
– The program indicator “MEMO” disappears from the
display, and the preset number that was stored is shown in
the right corner of the display.
• Repeat these steps for the other stations you wish to
programme.
Calling up preset stations
• Select the wave range with FM MW SW1 SW2 switch.
• Press one of the 1…5 buttons.
– The frequency and the PRESET number will appear on the
display:
