Bedienungsanleitung GT 615 (Seite 4 von 4) (Englisch)

554283

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

GT613UKRev02.p65

USER MANUAL - HOW TO USE THE ALARM

ARM/DISARM THE ALARM

By the original handset. Closing the doors the alarm sets after about 3” and opening the doors it unsets within

about 3”. For correct system operation, it is necessary to wait for at least 5” seconds between an arming

operation and a disarming operation.

WARNING: The emergency indicators (HAZARD) activation doesn’t

allow the alarm arming and disarming.

ELECTRIC WINDOWS CLOSURE COMMAND FUNCTION (IF CONNECTED)

The electric windows closure is controlled when arming.

PROTECTIONS

(1) Passive engine immobilisation

(2) Doors, boot and bonnet contacts. (When arming, you may observe a long flash of the indicators, it means

that a door hasn’t been correctly closed ).

(3) Power supply wires disconnection (for self-powered alarms and on armed alarms only). The interruption

of the positive feed (RED wire) doesn’t stop the vehicle (FAIL SAFE facility).

(4) Shock sensor protection.

(5) Additional sensors.

IF THE ALARM SOUNDS …

Should the siren activate, it will sound for about 28”. A press of the original

handset button will silence the siren

and disarm the alarm.

CHECK LED

Your alarm system is equipped with check control flashing LED in order to

verify an alarm state. If the alarm has been triggered when the vehicle

was unattended the LED will then start to flash irregularly according to the

triggered sensor (see table). Record the number of flashes and inform your

installer. NOTE: Two or more triggers on different sensors (i.e. doors and

bonnet) will be signalled in order by the LED (i.e. 4 - pause - 5 flashes -pause

- 4 - etc.).

DISARMING EMERGENCY

When it is not possible to disarm the alarm by the handset you may disarm the

alarm following the instructions on the GT CARD CODE.

TO ISOLATE THE ADDITIONAL SENSOR WHEN ARMING

When the alarm is disarmed open a door and switch the the ignition on and off twice. The LED starts to flash. Arm

the alarm; from this moment the additional shock sensor/s will be isolated.

To delete the additional sensor isolation operation it is necessary to disarm the alarm, or if it is already disarmed,

turn the ignition key once.

ARMING/DISARMING ACOUSTIC SIGNAL FACILITY

With this facility it is possible to have the acoustic signal “beep” when the alarm is arming or disarming.

FACILITY CHECK

It is suggested to check periodically the facility to obtain a system in working order.

WARNING:

To insert or to isolate the underlined facilities, contact your Installer.

LED

(flashes)

ENTRY SENSOR

2 additional

3 shock sensor

4 doors

5 boot/bonnet

6 ignition key

7 wires cut

WARRANTY CONDITIONS

This Certificate should be kept in a safe place and produced for verification should technical assistance be

required. Inability to produce this Certificate may affect your warranty rights. Warranty period bengins from date

of purchase and is valid for 12 months (24 months U.K.).

Should technical assistance be required during the warranty period, you should take your vehicle and this

Certificate to either the original installer or the nearest GT Auto Alarm Service Centre for inspection. Should any

part of the security system be found to be defective, and providing all component parts of the system are of GT

Auto Alarm manufacture, the defective part will be replaced or repaired free of charge. Warranty replacement/

repair does not include the following items:

1) damage caused in transit/carriage;

2)damage caused by incorrect or poor installation; problems which may be caused by anomalies in the vehicle’s

electrical system or originating from the environment in which the system is operated.

3) damage caused by carelessness, negligence, misuse or repair by unauthorised personnel.

Units returned to our organisation under the terms of the warranty will be replaced or repaired within a reasonable

time period according to our Company requirements.

Any repair/refurbishment received within the warranty period does not extend or renew the warranty itself.

Nobody is authorized to modify or replace anything in verbal or written format which alters the conditions of this

warranty.

The manufacturer reserves the right to modify or improve the specification.

The alarm only deters attempted theft. Our company cannot accept liability for any consequential damage or loss to

persons or property as a result of purchase of a GT Auto Alarm system.

Any correspondence for litigation purposes shall be received at our headquarters in Gavirate (Varese) - Italy.

Installation Certificate

We certify that the alarm system installation has been carried out following the

installation instructions and the information in the owner's guidehas been passed over

to the customer.

Warranty coupon

Alarm model:

ALARM MODEL: INSTALLATION DATE: INSTALLED ACCESSORIES:

POSSIBLE INSTALLED ACCESSORIES: STAMP AND INSTALLER SIGNATURE: INSTALLATION DATE:

MARK AND CAR MODEL: STAMP AND INSTALLER

SIGNATURE:

All GT Auto Alarm lines are homologated according to the European Directives.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

GT 615 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info