625750
5
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
GENERAL DESCRIPTION
Thank you for choosing this GYS product which has been designed with great care. To get the best out of
your machine, please read the following instructions carefully, and keep for future reference.
The GYSTARTs are designed to start vehicles with liquid or gel electrolyte lead-acid batteries and also charge
liquid or gel electrolyte lead-acid batteries. They are for use on 12V or 24V batteries with a capacity
according to the table below :
GYSTART
724E
924-230
1224T
Charge
20>1000 Ah
30>1100 Ah
65>1350 Ah
Start
45>200 Ah
45>250 Ah
60>300 Ah
ELECTRICITY SUPPLY
This device must be plugged into an EARTHED power supply with the following characteristics :
GYSTART
724E
924-230
1224T
Voltage
230V single ph.
230V single ph.
400V 3 ph.
Protection
16A
40A
16A
Recommended cable section for use on extension cables: 3 x 2.5 mm² (4 x 2.5 mm² for the 1224T).
USE IN STARTING MODE (START)
Prior precautions
Do not disconnect the battery from the vehicle. If the battery is disconnected it can lead to information being lost
and possible failure in starting the vehicle.
Connecting and disconnecting
Switch off the product by selecting position “0”.
Connect the clamps: red to + terminal, black tobattery terminal. Select the correct voltage 12 or 24 V
for the battery.
NEVER disconnect the battery from the vehicle
Switch on the product by selecting “I”
Proceed to pre-charge (if necessary) for a few minutes with a current of about 1/5
th
of the battery’s capacity.
Sit behind the steering wheel in order to activate the remote control switch and the ignition at the same time.
A 5 second period is usually enough to start. Repeat the operation if needed.
When the engine’s motor starts, release the remote control switch and switch the device off - position « O ».
Disconnect the clamps from the battery.
In « Electronic Control » position, Gystart protects the on-board electronics and avoids overvoltage
( : <14,8V : <29,6V). In Manual position, this protection is not activated.
USE IN CHARGING MODE (CHARGE)
Prior precautions
Choose a sheltered area with suitable ventilation.
Remove the battery caps (if present) and ensure the liquid level (electrolyte) is correct. Add some
distilled water if necessary. Carefully clean the lugs and terminals of the battery.
Check that the capacity (Amps per hour) and the voltage (Volts) are compatible with your charger.
Connecting and Disconnecting
Switch off the product by selecting position “0”. Then plug into the mains supply and turn the charge
current potentiometer to the lowest setting.
Select the correct voltage 12 or 24 V for the battery.
Connect the clamps: red to + terminal, black tobattery terminal.
Make sure you get good electrical contact.
Select the charging mode using the switch :
“Electronic control”: when the charging process is over, a light will illuminate.
“Manual mode”: stop the charging process when your battery starts to boil.
Be careful of explosive gas, avoid
flames or sparks.
Switch on the product by selecting “I”
After one minute of charge adjust the charging current using the control knob.
5
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gys GYSTART 924.230 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gys GYSTART 924.230

Gys GYSTART 924.230 Bedienungsanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info