Bedienungsanleitung Gys Wattmatic 140 (Seite 5 von 28) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

625727

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

WATTMATIC 100.140.170

WARNINGS

▪ Explosive gas, avoid ame and sparks. During the charge, the battery must be placed in a well

ventilated place.

▪ Protect against rain and moisture.

▪ Your charger must be plugged in an outlet linked to the ground.

▪ if the electricity supply cable is damaged, it must be replaced by the manufacturer, its after sales

service, or a person with the same qualications to avoid any dangers.

▪ Do not use in any cases to charge small batteries or for non rechargeable batteries.

▪ The battery terminal which is not connected to the frame must be connected rst. The other

connection must be done on the frame far from the battery and from the fuel canalization.

▪ After charging, plug off the charger from the outlet, then plug off the clamp from the frame and

the battery in the indicated order.

▪ The charger must be placed in such a way that the socket outlet is always accessible.

▪ The charger must not be used as toy by young children, or used by young children or disabled

persons without any supervision.

▪ This product is to be recycled by selective collection. Do not throw in domestic garbage.

▪ Do not make the clamps enter in short circuit during the charge.

▪ Acids Risk of projections

▪ The user must comply with the use and maintenance specied in this manual to protect them-

selves and those around him, against any risks related to the use of this charger.

GENERAL DESCRIPTION

Congratulations for the selection of this product, which has been designed with great care. To get

the best use of it, please read carefully the following instructions. Keep this instruction manual safe,

you may want to read it again later.

WATTMATIC is designed to charge starting liquid or gel electrolyte lead-acid batteries :

- from 15 Ah to 100 Ah in 6V or 12V for the WATTMATIC 100 (3 or 6 2V elements)

- from 20 Ah to 150 Ah in 6V or 12V for the WATTMATIC 140 (3 or 6 2V elements)

- from 25 Ah to 180 Ah in 6V or 12V for the WATTMATIC 170 (3 or 6 2V elements)

Load curve: WUoU. This curve ensures a 100% charge and maintains the level of charge thanks to

Floating.

CONNECTION IN CHARGER FUNCTION

Preliminary precautions

• For indoor use, with good ventilation.

• Remove the battery caps if there is, and check the level of liquid. If it is not correct; lled up with

distilled water. Clean well the battery terminals.

• Check if the battery capacity and voltage are compatible with your charger.

Connection and disconnection

• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good

electric contact, respecting the following order.

▪ Connect rst the battery terminal not connected to the chassis of the vehicle.

▪ Then connect the other connection to the chassis remote from the battery and any fuel line.

▪ At last, plug in your charger to 230 V 50/60 Hz mains supply.

Translation of the original instructions

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gys Wattmatic 140 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info