465491
18
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
18
MAINTENANCE
DISPLAY CODES
CODES CAUSES SOLUTIONS
Err1 ¬ Washer door is not properly shut.
_
Shut the door properly
Err2 ¬ Drainage error. Water is not emptied
within 4 minutes.
_
C l e a n t h e f i l t e r a n d c h e c k t h e d r a i n h o s e f o r b l o c k a g e .
Remove filter in case any water remains in the unit.
Err3 ¬ Temperature sensor error.
_
Please contact the Service Center.
Err4 ¬ Heater error or laundry overload. The set
temperature is not reached within specified
t i m e . ( A p p e a r s a t t h e e n d o f a c y c l e ) .
_
Reduce load and start washing again.
_
Please contact the Service Center.
Err5 ¬ Water level not met within 8 minutes.
_
Check the tap and the water pressure.
Err6 ¬ Dehumidification/heating error.
_
Please contact the Service Center.
Err7 ¬ Motor overheat error.
_
Please contact the Service Center.
Err8 ¬ Water overflow.
_
Please contact the Service Center.
Err9 ¬ E r r o r o f t h e d r y e r t e m p e r a t u r e s e n s o r .
_
Please contact the Service Center.
Er10 ¬ Error of the water level sensor.
_
Please contact the Service Center.
Er12 ¬ Error of the dryer water level sensor.
_
C h e c k w h e t h e r c l o t h e s a r e d r y o r n o t a n d w h e t h e r t h e r e i s
water still in the drum. If so allow excess humidity to
e s c a p e f r o m t h e a p p l i a n c e a n d t r y t h e d r y i n g c y c l e a g a i n .
Er13 ¬ Dryer heater error.
_
Please contact the Service Center.
unb ¬ Laundry is unevenly distributed.
_
Redistribute laundry to balance the drum.
EUAr ¬ Communication error.
_
Please contact the Service Center.
1:16 ¬ Status information: remaining program time is 1 hour and 16 minutes.
0:01 ¬ Status information: remaining program time is 1 minute.
60°C ¬ Status information: Wash temperature is 60°C.
--°C ¬ No heat (cold wash).
0 ¬ No spin.
800 ¬ Status information: Spin speed 800 rpm.
L- -1 ¬ Manually selected code when laundry weight is less than 1kg.
L- -A ¬ Manually selected code when drum is nearly full.
End ¬ Program is finished.
DISPLAY CODES AND SPECIAL FUNCTIONS
¬ C o n t r o l p a n e l l o c k f u n c t i o n : Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after
starting a program. It can no longer be changed by operating buttons or knobs. The washing machine emits an audible
signal while the control panel is locked. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program
cycle, the present settings will be saved and the preset operation will resume when the power is on again.
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Haier HWD C1200TXVE wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Haier HWD C1200TXVE

Haier HWD C1200TXVE Bedienungsanleitung - Deutsch - 20 seiten

Haier HWD C1200TXVE Bedienungsanleitung - Holländisch - 21 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info