534553
8
Zoom out
Zoom in
Vorherige Seite
1/11
Nächste Seite
AVR
8
AVR Setup
Set Up the AVR
Install the Batteries in the Remote Control
Remove the remote control’s battery cover, insert the two supplied AAA batteries as shown in
the illustration, and replace the battery cover.
1. Remove
Cover
2. Insert
Batteries
3. Replace
Cover
NOTE: Remove the protective plastic from the AVR’s front panel so it doesn’t reduce the
remote control’s effectiveness.
Using the Remote Control
You will be using the following remote-control buttons to congure your AVR:
Left/Right/Up/Down
Buttons
Back/Exit
Button
AVR
Button
OK
Button
OSD/Menu
Button
Turn On the AVR
Press the front-panel Power button.
Power Button
Configure the AVR for Your Speakers:
AVR 1710/AVR 171/AVR 1610/AVR 161
Note: The on-screen menus shown in this guide may differ slightly from your AVR’s actual
menu screens.
Before you use your AVR you need to congure it to work with your particular speaker
system. Your AVR’s EZSet/EQ
Plus system uses the supplied EzSet/EQ microphone to
detect the capabilities of each connected speaker and optimize the AVR’s performance
for them automatically. Before beginning, be sure you have correctly connected your
speakers to the AVR.
1. Plug the supplied EzSet/EQ
microphone into the AVR’s Headphone connector.
AVR Headphone Connector
EzSet Microphone (supplied)
2. Place the microphone at ear height in your listening position.
3. Turn on your TV and select the TV input where you connected the AVR in Connect Your
TV or Video Display, on page 4.
4. Press the remote control’s AVR button, then press the OSD/Menu button. The AVR’s
on-screen display (OSD) setup menu will appear on the TV. (Note: If you have used
a composite video connection to your TV, the OSD menus will not appear on your TV.
Follow the steps below using the AVR’s front-panel display.)
MASTER MENU
Source Select
Source Setup
Surround Mode
Speaker Setup
Zone2
Network
System Setup
5. Use the remote’s arrow and OK buttons to select “Speaker Setup.”
Speaker Setup
Auto: EZ Set/EQ
Manual Setup
6. Select “Auto: EZ Set/EQ.”
7. Select “Continue.”
8. Follow the instructions that appear on the screens. Remain quiet while the test noise
plays through the speakers.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Harman Kardon AVR 1710 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Harman Kardon AVR 1710

Harman Kardon AVR 1710 Bedienungsanleitung - Deutsch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Englisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Holländisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Dänisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Französisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Italienisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Spanisch - 52 seiten

Harman Kardon AVR 1710 Bedienungsanleitung - Polnisch - 52 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info