Bedienungsanleitung Hendi 272602 (Seite 3 von 144) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

742600

Zoom out

Zoom in

Vorherige Seite

1/144

Nächste Seite

Dear Customer,

Thank you for purchasing this Hendi appliance. Please read this manual carefully before connecting the

appliance in order to prevent damage due to incorrect use. Read the safety regulations in particular very

carefully.

Safety regulations

• This appliance must be used outdoors or in a well ventilated area, and should not be

installed or used indoors.

• Change the gas cylinder in a well ventilated area, away from any inﬂammation sources.

• The cylinder must be stored outdoors or in a well ventilated area.

• Storage this appliance indoors is permissible only if gas cylinder is disconnected and

removed from the appliance.

• Do not move this appliance when in operation, or after it has been turned off before the

temperature has cooled down.

• Do not attempt to alter the appliance in any manner. Do not paint the radiant screen,

control panel or reﬂector.

• Do not obstruct the ventilation holes of the cylinder housing.

• The appliance must be installed and gas cylinder stored in accordance with local gas

ﬁtting regulations.

• Shut off the valve at the gas cylinder or the regulator before moving the appliance.

• Use only the type of gas speciﬁed by the manufacturer.

• Repairs should be done by a qualiﬁed person.

• In case of violent wind, particular attention must be taken against tilting of the appliance.

• Check that the regulator seal is correctly ﬁtted and able to fulﬁl its function.

• Close the gas supply at the valve of the gas cylinder or the regulator after use.

• Do not use this appliance until all connections have been leak tested.

• In the event of gas leakage, the appliance shall not be used or if alight, the gas supply

shall be shut off and the appliance shall be investigated and rectiﬁed before it is used

again.

• Checking the tubing or the ﬂexible hose per month and each time the cylinder is changed.

• The tubing or the ﬂexible hose must be changed within the prescribed intervals or with

in one year. The ﬂexible hose should not extended than 1.5m according to standard

EN16436:2014.

• The hose assembly must be replaced prior to the appliance being put into operation if

there is evidence of excessive abrasion or wear, or if the hose is damaged, and that the

replacement hose assembly shall be that speciﬁed by the manufacturer.

• The heater should be inspected before use and at least annually by a qualiﬁed service

person. More frequent cleaning may be required as necessary. It is imperative that control

compartment, burners and circulating air passageways of the appliance be kept clean.

• Shut off and check heater immediately if any of the following conditions exist:

¨ The smell of gas in conjunction with extreme yellow tipping of the burner ﬂames.

NLEN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 272602 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info