488783
42
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
42
7 Additional information
It’s often easy to mistake incorrect operation for trouble and malfunction of the unit. If you think there is
something wrong with the component, check the points below first. If the problem persists, contact you
nearest HHB authorized service center and have them check over the unit.
Symptom Cause Remedy
Power cannot be
turned on.
The power cord is unplugged from the wall
outlet.
The power plug is not firmly connected to
the recorder.
Plug the power cord into a
power outlet.
Make sure that the power plug is
fully inserted in the recorder.
No sound is heard
during playback.
The recorder is not connected up properly.
Check all connections, especially
to the amplifier (p.10–11).
Cannot record.
The recorder is not connected up properly.
The CD-R or CD-RW disc in use has already
been finalized.
The input selection is incorrect.
The REC LEVEL control is set too low.
Check all connections (p.10–11)
Use a non-finalized disc or erase
the CD-RW disc (p.38).
Select the input for the correct
input source to the recorder.
Increase the recording level
(p.23–24).
Recorded sound is
distorted.
The REC LEVEL control is set too high.
Signal connections are incorrect.
There is interference from external
sources.
The disc is damaged or warped.
The disc is extremely dirty.
Reduce the recording level (p.23
–24).
Check all connections (p.10–11)
Turn the power off to other units
near the recorder until there is no
interference.
Use another disc.
Clean the disc.
Remote control
operation is
impossible.
The remote control batteries are
exhausted.
There is an obstacle between the remote
control unit and main unit.
The remote control unit is being operated
outside the remote controllable range.
Replace both of the remote
control batteries with new ones.
Remove the obstacle.
Operate in the remote
controllable range (p.9).
Some tracks are
skipped without
being played.
The SKIP PLAY button is set to on. Set the SKIP PLAY button to off
(p.28).
Skip playback does
not occur.
The SKIP PLAY button is set to off. Set the SKIP PLAY button to on
(p.28).
The recorder does
not recognize the
end of tracks
during sync
recording.
The level that the recorder regards as
‘silence’ is set either too low, or too high.
Set the silence threshold to a
suitable level for automatically
numbering tracks (p.33).
A recorded CD-R
disc cannot be
played on other CD
players.
The disc has not been finalized after
recording. When such a disc is loaded, the
CD-R indicator lights up.
The pickup lens of the other CD player is
dirty, impairing its ability to play CD-R discs.
Finalize the disc (p.26).
Try the disc on a different CD
player. If it plays OK then get the
pickup lens on the original player
cleaned.
42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für HHB CDR-830 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info