505730

Hifonics MT OLYMPUS Seite 4

4
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
AMPLIFIER FEATURE DESCRIPTIONS
2
MT OLYMPUS AMPLIFIERS:
A POWER LED indicates the powered up and turned on condition.
This is a unique series of amplifiers regarding channel stability and design.
All HIFONICS amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit,
The COLOSSUS and COLOSSUS PRO are stable at 4/2/1-Ohm per channel and 4/2-Ohms bridged.
and amplifier DC faults indicated by the red “PROTECT” LED.
The BOLTAR and JUPITER are stable at 4/2-Ohms per channel and 4-Ohms bridged.
CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU
The HERCULES and ATLAS is stable at 4/2/1-Ohm.
The input sensitivities for rated output powers are variable from 0.2V to 9V.
WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE
All crossovers are fully variable in their respective ranges.
WARRANTY PRINTED IN THE BACK OF THE MANUAL.
Crossover filters are 12dB/Octave.
FEATURES FOR BOLTAR / COLOSSUS PRO / JUPITER:
X-OVER:
-FULL RANGE: Bypasses all frequency adjustments except Subsonic.
-HP: High Pass operation uses Subsonic to cutoff the low frequencies and the FREQUENCY
adjustment can be used to create a sharper cutoff on the low end.
-LP/BP: Low Pass/Band Pass operation which allows for use of the Subsonic and Frequency
(Low Pass) shaping controls.
LOW PASS X-OVER:
-LP/BP STEREO 12dB/OCT: Stereo operation with a smooth 12dB/octave rolloff.
-LP DIRECT MONO 24dB/OCT: Bridged operation with a sharp 24dB/octave cutoff.
SUBSONIC FILTER: Low frequency cutoff variable from 15Hz to 150Hz.
PARAMETRIC EQ:
-X1 or X10 FREQUENCY MULTIPLIER: Multiplies frequency of enhancement in PARAMETRIC EQ.
-FREQUENCY: Variable enhancement from 40Hz to 400Hz at X1 or 400Hz to 4000Hz at X10.
-BANDWIDTH: Narrow to Wide range enhancements above and below the center FREQUENCY.
-CUT/BOOST: -10 to +10 enhancements centered at the FREQUENCY selected.
FREQUENCY: Variable from 40Hz to 400Hz at X1 and 400Hz to 4000Hz at X10 enhancement on
the multiplier. This FREQUENCY function varies based on the X-OVER selections described above.
PHASE: Variable time alignment from 0 to 180 degrees for both LEFT and RIGHT channels.
INPUT LEVEL: Variable from 0.2V to 9V.
FULL RANGE OUTPUT: Passes RCA signal through the amplifier unchanged by settings.
LINE INPUT: RCA Inputs.
FEATURES FOR JUPITER ONLY:
MODE: Internal routing of RCA signal. Selecting 2CH indicates RCA’s are being connected to Channel
1&2 Inputs and the amplifier will internally route signal to Channels 3&4. Selecting 4CH indicates RCA’s
are being connected to Channel Inputs on 1-4.
FEATURES FOR COLOSSUS / HERCULES / ATLAS:
LINE INPUT: RCA Inputs
FULL RANGE OUTPUT: Passes RCA signal through the amplifier unchanged by settings.
INPUT LEVEL: Variable from 0.2V to 9V.
PHASE: Variable time alignment from 0 to 180 degrees.
PARAMETRIC EQ:
-FREQUENCY: Variable enhancement from 30Hz to 100Hz.
-BANDWIDTH: Narrow to Wide range enhancements above and below the center FREQUENCY.
-BOOST: 0 to +10 enhancements centered at the FREQUENCY selected.
SUBSONIC FILTER: Low frequency cutoff variable from 15Hz to 35Hz.
LOW PASS FILTER: High frequency cutoff variable from 35Hz to 250Hz.
MODE (HERCULES/ATLAS ONLY):
-MASTER OUT: Factory setting for the switch location when using the amp alone. Also used when
linking a pair of HERCULES/ATLAS amplifier at 2-Ohms. When in MASTER OUT position, a single
RCA can be connected to the MASTER OUT RCA receptacle to provide signal to the SLAVE INPUT
on the SLAVE amplifier.
-SLAVE IN: Your MODE switch should only be in this position if you are linking a pair of
HERCULES/ATLAS amplifiers and this amp is the SLAVE. At that point the SLAVE amp will receive
the single RCA on the SLAVE IN. No other RCA’s can be connected to your amplifier other than
SLAVE IN when in SLAVE IN position.
BALANCED INPUT (COLOSSUS ONLY): DIN connection which is a step above the standard RCA
signal as it accepts from 0.4V to 18V.
These amplifiers feature two DIAGNOSTIC LED’s.
One monitors Short Circuits and Thermal Protection while
the second monitors Clipping status.
These amplifiers feature two DIAGNOSTIC LED’s.
One monitors Short Circuits and Thermal Protection while
the second monitors Clipping status.
BOLTAR / COLOSSUS PRO 2-CHANNEL AMPLIFIERS
JUPITER 4-CHANNEL AMPLIFIERS
HERCULES / ATLAS MONO AMPLIFIERS
COLOSSUS DUAL MONO AMPLIFIERS
LL
RR
HFR-G1
REMOTE
SUBSONIC FREQUENCY BANDWIDTH CUT/BOOST
FREQUENCY RIGHT LEFT INPUT LEVEL
PARAMETRIC EQ
PHASE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
FULL RANGE
X1 X10
FULL RANGE
OUTPUT
LINE
INPUT
15Hz 150Hz 40Hz 400Hz Narrow Wide -10dB +10dB
40Hz 400Hz 0 180 0 180 9V 0.2V
X1 X10
LP/BP
STEREO 12dB/OCT
MONO 24dB/OCT
LP DIRECT
HFR-G1
REMOTE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
CROSSOVER
PARAMETRIC EQ
PARAMETRIC EQ
HP
FULL RANGE
FULL
X1
X1
4CH
MODE
X1
X1
X10
X10
2CH
X10
X10
LINE INPUT
CH 3&4
CH 1&2
FREQUENCY FREQUENCY BANDWIDTH BOOST SUBSONIC LEVEL
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 15Hz 150Hz 9V 0.2V
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 9V 0.2V
FREQUENCY FREQUENCY BANDWIDTH BOOST LEVEL
4Ch
MONO MIX
OUTPUT
Ch1 Ch3
Ch2 Ch4
LL
RR
LEVEL PHASE BOOST BANDWIDTH FREQUENCY SUBSONIC LOW PASS
9V 0.2V 0 180 0dB +10dB NARROW WIDE 30Hz 100Hz 15Hz 35Hz 35Hz 250Hz
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
MASTER OUT
SLAVE IN
MODE
HFR-G1
REMOTE
PARAMETRIC BASS EQ
FULL RANGE
OUTPUT
MASTER
OUT
SLAVE
IN
LINE
INPUT
LL
RR
LEVEL PHASE BOOST BANDWIDTH FREQUENCY SUBSONIC LOW PASS
9V 0.2V 0 180 0dB +10dB NARROW WIDE 30Hz 100Hz 15Hz 35Hz 35Hz 250Hz
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HFR-G1
REMOTE
BALANCED
INPUT
PARAMETRIC BASS EQ
FULL RANGE
OUTPUT
LINE
INPUT
… 4 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics MT OLYMPUS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info