139867
7
Zoom out
Zoom in
Vorherige Seite
1/50
Nächste Seite
7
rear socket and scart details
CENTER
AUDIO IN
VIDEO OUT
AUDIO OUT
S-VHS
L
Y
CB
R
L
R
PR
CB
PR
FMS5011
Use this socket to
connect ordinary VHS,
S-VHS or Hi8
equipment to your TV.
(Connect VCR to AV1
for Viewlink).
Use this to connect digital
video broadcasting equipment
and home entertainment
systems to your TV. for RGB
input
This should be permanently
connected to an RF source -
i.e your aerial antenna.
AV2·AV3scart input
AV1 scart input
RF aerial socket
important note on installation
If you intend placing this TV into a cabinet or wall alcove, please ensure there is at least a
100mm (10cm) gap to the sides, rear and top of the television. This is to allow for adequate
ventilation.
Do not allow soft furnishings, such as curtains to be draped over the TV whilst in operation.
Never place the TV onto a carpet during normal operation - this could obstruct ventilation slots
on the base of the TV.
Always place the TV on a flat surface, or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or even, in
extreme cases, fire.
Use this to connect digital
video broadcasting equipment,
home entertainment systems
and DVD players etc. to your
TV.
AV4 component input
This should be connected
to the Mains Supply via
the supplied Mains Lead.
Mains Socket
These should be
connected to your
plasma screen via the
link lead.
Link Sockets
Use this to connect to
your computer if
desired.
VGA input
These sockets can be used to connect to external equipment to
supply a picture only, (no menus or Text), e.g. to a video projector.
S-VHS out is not available when receiving
SECAM signal, AV4 and S-VHS input
Output sockets (S-VHS monitor out & video out)
AUDIO VISUAL CONTROL
(AVC) UNIT
PLASMA SCREEN
This should be connected
to the Mains Supply via
the supplied Mains Lead.
Mains Socket
These should be
connected to your
AVC Unit via the link
lead.
Link Sockets
These sockets can be
used to connect to
external amplifier or Hi-Fi
system.
audio output (RCA)
This socket can be used
to connect a SubWoofer
speaker.*
SubWoofer
Use this button if you wish to test the functionality of the
plasma screen without the AVC unit being attached.
Press and hold this button for more than 5 seconds and a
test picture will be displayed on the screen.
test button
*If this product is used with an active SubWoofer, it is possible to change its frequency by
adjusting the LPF (Low Pass Filter) control on the Subwoofer speaker. This will enable you to
select the most suitable sound performance.
X832136-02-02(En) 9/13/02 10:38 AM Page 7
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi 32 pd 3000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Hitachi 32 pd 3000

Hitachi 32 pd 3000 Bedienungsanleitung - Deutsch - 50 seiten

Hitachi 32 pd 3000 Bedienungsanleitung - Holländisch - 50 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info