Bedienungsanleitung Hitachi CF18DSL (Seite 7 von 220) (Alle Sprachen)

616692

Zoom out

Zoom in

Vorherige Seite

1/220

Nächste Seite

English

● Regarding the temperatures and charging time of the

battery.

The temperatures and charging time will become as

shown in Table 2.

Table 2

Charger

Battery

UC18YFSL

Charging voltage V 14.4 – 18

Weight kg 0.5

Temperatures at which the

battery can be recharged

0oC – 50oC

Charging time for battery

capacity, approx. (At 20oC)

1.5 Ah

2.0 Ah

2.5 Ah

3.0 Ah

4.0 Ah

5.0 Ah

min.

Number of battery cells 4 – 10

NOTE

The recharging time may vary according to temperature

and power source voltage.

CAUTION

When the battery charger has been continuously used,

the battery charger will be heated, thus constituting

the cause of the failures. Once the charging has been

completed, give 15 minutes rest until the next charging.

4. Disconnect the charger’s power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

CAUTION

 If the battery is charged while it is heated because it has

been left for a long time in a location subject to direct

sunlight or because the battery has just been used, the

pilot lamp of the charger lights for 1 second, does not

light for 0.5 seconds (o for 0.5 seconds). In such a case,

ﬁ rst let the battery cool, then start charging.

○ When the pilot lamp ﬂ ickers (at 0.2-second intervals),

check for and take out any foreign objects in the charger’s

battery connector. If there are no foreign objects, it is

probable that the battery or charger is malfunctioning.

Take it to your authorized Service Center.

○

Since the built-in micro computer takes about 3 seconds to

conﬁ rm that the battery being charged with charger is taken

out, wait for a minimum of 3 seconds before reinserting it

to continue charging. If the battery is reinserted within 3

seconds, the battery may not be properly charged.

 If the pilot lamp does not blink in red (every second)

even though the charger cord is connected to the power,

it indicates that the protection circuit of the charger may

be activated.

Remove the cord or plug from the power and then

connect it again after 30 seconds or so. If this does

not cause the pilot lamp to blink in red (every second),

please take the charger to the Hitachi Authorized Service

Center.

REGARDING ENVIRONMENT AND

CONDITIONS OF USE

This tool operates on oil pressure.

When used during the winter season or in cold conditions

the hydraulic oil’s viscosity will excessively rise to dull the

tool’s operation.

In such cases, run the tool through a warm-up operation

prior to use.

How to run a warm-up operation

Without setting up a rebar, switch on the tool and let it

continuously run for 30 to 60 seconds.

WARNING

Do not place your hands in the vicinity of the piston

during warm-up operation.

Depending on the environment and conditions of use, the

hydraulics may heat up (over 50°C). This can lower the

viscosity of the hydraulic oil and reduce its cutting power.

If this occurs, allow the tool to cool down and then resume

operation.

Table 1

Indications of the pilot lamp

Pilot lamp

(red)

Before

charging

Blinks

Lights for 0.5 seconds. Does not light for 0.5

seconds. (o for 0.5 seconds)

While charging Lights

Lights continuously

Charging

complete

Blinks

Lights for 0.5 seconds. Does not light for 0.5

seconds. (o for 0.5 seconds)

Overheat

standby

Blinks

Lights for 1 second. Does not light for 0.5

seconds. (o for 0.5 seconds)

Battery overheated.

Unable to charge.

(Charging will commence

when battery cools)

Charging

impossible

Flickers

Lights for 0.1 seconds. Does not light for 0.1

seconds. (o for 0.1 seconds)

Malfunction in the battery

or the charger

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi CF18DSL Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info