78675
6
Zoom out
Zoom in
Vorherige Seite
1/74
Nächste Seite
English
5
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle 3 tightly and push the battery latch
2 to remove the battery 1 (See Fig. 1 ).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery 1 while observing its polarities
(See Fig. 1).
CHARGING
Before using the impact driver or impact wrench, charge
the battery as follows.
1. Connect the charger’s power cord to a receptacle
When the power cord is connected, the charger’s
pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Insert the battery firmly, until it contacts the bottom of
the charger compartment.
CAUTION
If the battery is inserted in the reverse direction, not
only recharging will become impossible, but it may
also cause problems in the charger such as deformed
recharging terminal.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals) (See
Table 1).
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Charger
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using
this product, even if you are pulling the switch, the
motor may stop. This is not the trouble but the result
of protection function.
Cordless Impact Wrench
Model WH14DL WH18DL
Voltage 14.4 V 18 V
No-Load speed 0 – 2600 min
-1
Capacity (Ordinary bolt) M6 – M14
Tightening torque (Maximum) 140 N·m 150 N·m
Rechargeable battery 3.0 Ah
EBL1430: Li-ion (4 cells)
EBM1830: Li-ion (10 cells)
BCL1430: Li-ion (4 or 8 cells)
Weight 1.5 kg 1.6 kg
Model WR14DL WR18DL
Voltage 14.4 V 18 V
No-Load speed 0 – 2600 min
-1
Capacity (Ordinary bolt) M10 – M16
Tightening torque (Maximum) 200 N·m 220 N·m
Rechargeable battery 3.0 Ah
EBL1430: Li-ion (4 cells)
EBM1830: Li-ion (10 cells)
BCL1430: Li-ion (4 or 8 cells)
Weight 1.5 kg 1.6 kg
Model UC18YRL
Charging voltage 7.2 – 18 V
Charging time 3.0 Ah 45 min.
Weight 0.6 kg
1. When the battery power remaining runs out (The
battery voltage drops to about 12V (WH18DL,
WR18DL) / about 8V (WH14DL, WR14DL)), the
motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
SPECIFICATIONS
Cordless Impact Driver
Charge time is approximate. Actual charge time may
vary.
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi WH 14 DL wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Hitachi WH 14 DL

Hitachi WH 14 DL Zusatzinformation - Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch - 86 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info