30184
4
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
Hitec off ers the NEON in se ver al versions , some complete with rechargeable transmitter batteries and some
"dry" using "alkaline" (non-rechargeable) batteries. Should your system come "dry", consider the option of
adding individual NiCad cells to your battery holder or replacing the battery holder with the optional Hitec
NiCad battery pack, part number 58207. Both packs can be charged with Hitec's ov ernight wall chargers
as noted abov e.
Reading the LED Battery Indicators
There are three indicator lights on the f ace of the radio marked High (green), Mid (amber) and Low (red).
These relate to the condition of your transmitter battery. Please pa y attention to these LEDs and stop flying when
the red "Low" light is on.
Rechar ging Nicad batteries
4
MID
HIGH
LOW
Full Po wer : Green
MID
HIGH
LOW
Normal : Amber
MID
HIGH
LOW
W arning : Flashing Red
CG-25 or CG-22A
#54402 AAA size RX Battery box
#57401 RX Nicad (Not included)
#54403 MICRO S/W HARNESS
Installing Transmitter Batteries
The Delux e NEON version transmitter is supplied with rechargeable Nicad batteries.
Bef ore using the radio , plug the supplied 110V. CG-25 or 220V. CG-22A overnight wall charger into a normal
household A C wall sock et. There are two leads on the CG-25 or CG-22A, the round one plugs into the sock et
on the lower left side of the transmitter . The green light on the CG-25 or CG-22A should glow, confirming
charging is taking place; leav e it on charge f or at least 18 hours. Once fully charged, the transmitter should
operate f or about 120 minutes. Typically you will charge the radio up ov ernight before flying the ne xt da y.
Do not leav e the radio connected to the wall charger f or ov er 36 hours or permanent damage to the transmitter
battery pack ma y occur .
To install or change the batteries in your NEON
Split the case as described in section 4, Set-up and Operation on page 3,
Remov e the battery holder .
Install batteries as shown in image.
Reinstall the battery holder .
Note:The NEON transmitter char ging circuitry uses a Diode.
This means Hitec cannot recommend the use of "peak" char gers
to charge y our NiCad pack within the NEON case.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitec NEON_SS_FM wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info