Bedienungsanleitung Homedics PED-1300-EU (Seite 3 von 14) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

690048

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

2 I GB

3 I GB

Charging the batteries

When the level indictor LED ashes red, the

product needs charging. Connect the charging

base to a USB power supply using the lead

provided. Place the unit in the charging

base. The LED light will ash to indicate that

charging is taking place. When charging is

complete green LED will stay on. It takes 2

hours for a full charge, which will provide 90

minutes use, dependent on power levels used.

How to use

1. Ensure that your feet are clean and dry.

2. Use the switch to select a power setting;

For sensitive skin, or softer skin use the LO

setting.

For harder skin use the HI setting.

3. Using light pressure place the surface of

roller onto the heel or sole of your foot and

gradually move the device around to target

areas of hard skin. Do not use on a single

area for more than 4 seconds at a time.

4. Check the results throughout. Once you are happy with the results

turn the switch to OFF.

5. Rinse your feet with clean water & dry before applying your

favourite foot cream.

Cautions

Before use, make sure that the roller is in good condition. Any

malformation, distortion or damage may cause skin injury.

DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP

ROTATING. FOR BEST RESULTS, RUN THE UNIT GENTLY OVER THE SKIN.

THIS WILL ENSURE SOFT, SAFE AND SMOOTH REMOVAL OF DEAD SKIN.

INSTRUCTIONS FOR USE:

PRODUCT FEATURES

Main body

Power switch

Changing the rollers

To remove the roller.

1. Ensure the switch is in the OFF position.

2. With one hand press the release button on

the side of the device.

3. With the other hand lift out the roller.

TIP: It’s easier to lift the roller out from the

end closest to the release button.

To insert a new roller.

1. Loosely position one of the roller pins into the recess on the end

furthest from the release button.

2. Push the other end of the roller into place using the groves to guide

it into position.

3. The roller will secure into place with a click.

MAINTENANCE AND STORAGE

• Always turn the device o before cleaning it.

• Only clean the device with the supplied brush or a dry cloth. Do not

use chemical agents including benzene, alcohol etc.

• Batteries (battery pack or batteries installed) shall not be exposed to

excessive heat such as sunshine, re or the like.

• Your PED 1300 includes a rechargeable battery designed to last the

lifetime of the product. In the unlikely event that you should require

a replacement battery please contact Customer Services who will

supply details of the warranty and out-of-warranty replacement

battery service.

• If roller surface becomes worn or less abrasive, t a new roller.

Extra coarse

roller: white edge

Release button

LIGHT APPEARANCE MEANING

Red LED On Device on and battery low

Red LED Flashing Battery charging

Green LED On Device fully charged

LED O Device not in charging base and is switched o

Fine roller: grey edge

(where supplied)

Charging station

Storage for

replacement

rollers

Coarse roller:

blue edge

Cleaning brush

USB charging

cable

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Homedics PED-1300-EU Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info