Bedienungsanleitung Honeywell HCE200 Series (Seite 5 von 21) (Englisch, Französisch, Spanisch)

723863

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

The UberHeat

Ceramic Heater is equipped with several devices and features for added protection:

• A four way tip-over switch disables the heater if it is accidentally tipped in any direction.

If tipped over, the unit should be set upright and follow the OPERATION instructions.

• A high temperature safety control prevents overheating. If activated, unplug the device and wait

at least 10 minutes or allow the unit to cool completely. Then plug the heater back in and follow

the OPERATION instructions.

• The heater is also equipped with a thermal cut-off fuse that will permanently shut down the

heater should it operate at a higher than normal temperature. If activated, the unit will need

to be replaced.

• This heater was created using a high quality, heat resistant plastic and has a Cool to Touch housing.

TROUBLESHOOTING

If your UberHeat

Ceramic Heater shuts off unexpectedly or fails to operate, one of your heater

safety features may have been activated to prevent overheating.

• Be sure it is plugged in and that the electrical outlet is working.

• Check your Thermostat Control setting. The unit may simply

be off because you have reached your desired heat setting.

• Check for any obstructions. If you find an obstruction, turn

the heater OFF ( ) and unplug it. Allow the heater to cool

completely, then remove the obstruction. Wait at least

10 minutes, then plug the heater back in and follow the

OPERATION instructions.

• Check to ensure that metal stand does not rest on top of

power cord. This could activate the tip-over switch. Cord should

be routed through the metal stand.

PRODUCT SPECIFICATIONS

CONSUMER RELATIONS

Call us toll-free at: 1-800-477-0457

E-mail: consumerrelations@kaz.com

Or visit our website at:

www.HoneywellPluggedIn.com/Heaters

Please be sure to specify a model number.

NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE

YOUR WARRANTY. DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT

ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND

CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.

Model HCE200 Series

Unit dims 7.8" L x 6.4" W x 10.9" H

Amps 12.5

Unit Voltage 120V, 60Hz

Max Watts 1575

Max BTUs 5118

Operation Cost* To estimate the cost to operate this heater, multiple the watts used times .001 to

convert into a kilowatts measure and multiple by your local kilowatt electric rate for however long

you run the heater. For example, if your electric rate is $.1196**per kilowatt hour and you ran this

heater in constant high mode (1500 watts) for 4 hours, it would cost you $.71 cents to run the

heater (1500 watts x 4 hours x.001) x .1196kwp = .71 cents.

NOTE: Because the Low setting does not require as much electricity to operate, it is more energy

efficient and may be a better option if you are concerned about the higher power consumption when

the heater is on the High setting.

* Calculation (Total Wattage x .001) x Cost per Kilowatt Hour = Cost to operate

** Average Retail Price of Electricity to Ultimate Customer by End-Use, US Energy Information

Administration, March 2013.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HCE200 Series Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info