Bedienungsanleitung Honeywell HEV615 series (Seite 3 von 29) (Englisch, Französisch, Spanisch)

723827

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

4 5

Option 1: To Fill Tank at the Humidiﬁer

1. Pour cool water from a pitcher or jug directly into the Water Tank. It is not necessary

to remove the Tank Cover. DO NOT overﬁll.

CAUTION: DO NOT pour water into the Grill

Option 2: To Fill Tank at the Sink

1. Grasp Tank Handle and pull Tank forward to remove from Base. Carry Tank to sink.

2. Remove Tank Cover if desired. Tank may also be ﬁlled through the openings in the

Tank Cover.

3. Fill Tank with cool water. DO NOT overﬁll. Replace the Tank Cover if it was removed.

4. Carry Water Tank back to humidiﬁer and replace on Base.

CAUTION: Use care when handling Water Tank to avoid unnecessary impact.

Banging or dropping the Water Tank could result in damage to the Tank that

may cause leaking.

This humidiﬁer uses a ﬂoat system to regulate the water ﬂow from the Tank to the Reservoir.

The Float Paddle must be properly installed for the unit to operate. If not properly installed,

water may not ﬂow into the Reservoir or it may leak from the Base. The Float Paddle is

designed to be easy to install and remove.

CAUTION: Improper placement of the Float Paddle could result in leaking or water

not feeding to the Reservoir.

1. Remove Water Tank.

2. Line up Float Paddle with the ﬂoat paddle shape on the bottom of the Reservoir.

3. Place Float Rod over the Brackets and press ﬁrmly until you hear it click into place.

4. Pull gently up on the Float Rod to be sure it doesn’t pop out of the Brackets.

5. Place Water Tank back in Base.

Float Paddle Installation – required for humidiﬁer to operate

Both ﬁlling options can be performed with or without the Tank Cover in place. Be sure to

replace the Cover before using the humidiﬁer to keep opjects and debris out of the water.

Note:

Ensure the Float Paddle has been placed correctly in the Reservoir before ﬁlling.

See Float Paddle Installation instructions if necessary

Consumer assumes all responsibility for property damage resulting from improperly

ﬁlled humidiﬁer.

FILLING/REFILLING THE WATER TANK

FILLING/REFILLING THE WATER TANK (CONTINUED)

The Tank can be ﬁlled in two ways:

Option 1: At the Humidiﬁer Option 2: At the Sink

DO NOT ADD ESSENTIAL OILS to the water tank. Doing so could cause damage to the

humidiﬁer and void the warranty.

This humidiﬁer holds a maximum of 1.7 gallons (6.4 liters) of water.

Option 2

Step 4

Step 1

Step 2

Step 3

SETTING UP YOUR HUMIDIFIER

Step 2

Step 1

✔

Option 1

Unpack the Humidiﬁer

Keep this instruction manual for reference.

1. Remove packaging materials. Locate

Float Paddle and set aside. This is

required for operation.

2. Remove twist tie and extend power cord.

Place on a ﬁrm, level, water resistant

surface a minimum of 12 inches (30 cm) from walls.

Step 1

Step 2

Step 5

Step 1

Step 3

Step 4

Float

Paddle

Float

Rod

Brackets

“Click”

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HEV615 series Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info