Bedienungsanleitung Honeywell HEV685 series (Seite 4 von 18) (Englisch, Französisch, Spanisch)

723837

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

6 7

To prolong the life of your Wicking Filter, turn it over each time you ﬁll the Water

Tank. This will keep the top of the Filter from drying out and will help the Filter

to age more evenly.

If you notice the Filter getting hard, you may soak it in cool water to loosen mineral

buildup. This will temporarily improve performance of the Wicking Filter until a

replacement Filter is purchased.

DO NOT attempt to clean the Wicking Filter with vinegar, soap or any chemical

solutions. Doing so may damage the Filter.

Protec

antimicrobial layers in the Wicking Filter help to prevent growth of mold on the Filter. However, the

Filter still needs to be replaced regularly. Humidiﬁer Filters and accessories require replacement and are not

covered under warranty.

CARING FOR YOUR FILTER

It is recommended you change your Wicking Filter every 30-60 days depending

on water quality and usage. If you have hard water you may need

to replace your Filter more frequently.

Change your Filter if you notice:

• The Filter is hard and crusty • The Filter starts to give off an odor

• Moisture output is decreased

Be sure to use only genuine Honeywell Replacement Filters which are

Protec

antimicrobially treated. It helps prevent the migration of mold,

algae and bacteria on the ﬁlter.

Replacement Wicking Filter

Honeywell HC-14 Series, Filter E

Follow steps 1-3 under Before Cleaning, then follow the additional steps below.

NOTE: Filter must be removed from humidiﬁer during cleaning;

DO NOT clean Filter with vinegar.

1. Pour up to 2 cups of undiluted distilled white vinegar into each Water Tank. Swish vinegar around in Tank

to wet entire inside of Tank.

2. Place Tanks on Base. Vinegar will drain into Water Reservoir and loosen mineral buildup (Scale) in

Base, Reservoir and bottom of the two Water Tanks. Allow vinegar to remain in the Tanks and Base for

20 minutes.

3. Empty vinegar from Tanks and Base and use a cloth or soft brush to help remove scale.

Remove Float Paddles and wipe clean with vinegar. Replace Float Paddles and ensure each one is secured

in both brackets. See Float Paddle Installation instructions in the Setting Up Your Humidiﬁer section.

4. Rinse Base and Reservoir with clean water until the smell of vinegar is gone.

Step 3

Step 4

Step 2

Step 1

Scale Removal

CARING FOR YOUR HUMIDIFIER

Step 2

Step 1

1. Turn off and unplug humidiﬁer. Never clean the humidiﬁer when it is running.

2. Empty water from Water Tanks.

3. Remove Motor Housing, Wicking Filter and any other accessories from humidiﬁer and set aside.

Before Cleaning

Step 3

MINUTES

Power Control

1. With Power Knob in the OFF position, plug humidiﬁer into a polarized 120V outlet.

CAUTION: To avoid electric shock, do not plug humidiﬁer into outlet with wet hands.

2. Turn the Power/Output knob to desired fan setting.

High (

): Fast humidifying Medium ( ): Everyday moisture control Low ( ): Quiet setting

Humidity Control

3. Turn the Humidity Level Knob to the highest setting and run for at least an hour or until a comfortable

humidity level is reached.

4. Once comfortable, turn the Humidity Level Knob to the left until the green Humidity Reached Indicator light

turns on (

) and the humidiﬁer turns off. This is your desired humidity level. Now that your desired

humidity level is set, the humidiﬁer will automatically turn back on when your room drops below this

comfort setting and will automatically turn off again when the comfort setting is reached.

NOTE: For continuous operation, set to high (

Water Tanks

5. When both Water Tanks are empty, the humidiﬁer will automatically shut off and the orange Reﬁll Indicator

(

) will light up. Turn off the humidiﬁer and reﬁll the Tanks. See Filling/Reﬁlling Water Tanks on

previous page.

NOTE: If the humidiﬁer will not be used for more than a few days, empty the water from the Water Tanks

and Water Reservoir and dry out the Filter to prevent growth of bacteria or mold

Step 2

Step 1

Step 3 Step 4 Step 5

USING YOUR HUMIDIFIER CARING FOR YOUR FILTER (Continued)

NOTE: While the humidiﬁer is operating, you will hear the fan running but

will not see the moisture output. This is normal for an evaporative humidiﬁer.

To check the humidity level in the room, use a humidity monitor like

the Honeywell HHM10 or H10C, available at retailers or online at

www.HoneywellPluggedIn.com.

To keep your humidiﬁer running efﬁciently, clean it regularly. Weekly cleaning is recommended. All

maintenance should be done in the kitchen or bathroom on a water resistant surface near a faucet.

DO NOT wash any components of this humidiﬁer in a dishwasher.

To properly clean your humidiﬁer we recommend the separate processes of Scale Removal and Disinfecting.

These two processes must be done separately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HEV685 series Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info