724048
4
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
4
Model HHF565 Series – Digital TurboForce® Heater Operation
Turn heater on by pressing the Power Button (
).
The Power Indicator will illuminate and the heater
will start in the Low (
) heat level setting (Fig. 4).
This heater has two operational modes, which can be
chosen using the red switch on the back of the unit
(Fig. 3):
Continuous heating (
) – heater will run until it
is manually shut off.
AutoOff (
) mode - heater will automatically shut
off after 8 hours each time that you use the heater.
This built-in feature helps ensure that the heater is not
accidentally left on for an extended period of time.
NOTE: See the SafeGuard® Auto-Off Feature section for more information on this feature.
This heater comes pre-set from the factory with the AutoOff mode engaged. When the unit is turned on,
the AutoOff icon (
) will be illuminated on the top of the controls. All features are functional while operating in
the AutoOff mode.
Should you NOT want the heater to automatically shut off after 8 hours, switch to Continuous heating by simply
pressing the red switch on the back of the unit. Once selected, the Continuous heat icon (
) will illuminate on the
top of the control panel.
To select a Heat Setting, press (
):
1. For Low (
), this setting uses 750 watts of power
2. For High (
), this setting uses 1500 watts of power
NOTE: The Low (
) setting does not require as much electricity to operate. It is more energy efficient and may
be a better option if you are concerned about saving energy.
To use the Fan only (no heat), press the Fan button (
).
To set the thermostat, continue to press the Heat Level button (
) until Auto is illuminated. There are 4 pre-set
comfort settings from which to choose: 65°, 70°, 75°, 80°. Continue to press the Heat Level button to select your
desired room temperature setting. The heater will operate at HIGH heat in order to reach this desired temperature.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will be off until the room
temperature falls below your desired temperature.
To set the Timer, press the (
) button to select 1, 2, 4, or 6 hour setting. The heater will run for that chosen period
in the selected mode and automatically shut off after the desired time has passed.
OPERATION
Fig. 3
Fig. 4
Fan Level
Heat Levels
Heat Temperature
SafeGuard® Auto Shut-Off
Auto Heat
Oscillation
60º 90º 120º
Power Button
Fan Button
Timer Button
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honeywell HHF550 series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info