604003
3
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
3
You can continue to refill the
humidifier even if the unit has
not run out of water.
Placement
Select a firm, level location at least 12” (30cm) from any walls.
Place the humidifier on a water-resistant surface.
Kaz will not accept responsibility for property damage
caused by water spillage.
WARNING
KEEP OUT OF REACH OF CHILDREN. This product produces HOT STEAM and
should be placed in an area not accessible to children or pets with the power cord also
securely out of reach.
SETTING UP YOUR HUMIDIFIER
Remove from box
Remove packaging material. Set aside instruction manual. Recycle
packaging materials or save for storage.
Ensure Proper Assembly
Make sure float and mist dome/mist chimney are securely in place.
Remove twist tie from power cord and extend power cord full length.
Do not operate humidifier with power cord coiled or tied or if its power
cord is damaged. See page 6 for detailed assembly information.
If the unit runs out of water, the
refill light will illuminate.
To reset the humidifier, turn the
unit off, fill water tank/fill area
with cool water, wait 15 minutes
and turn unit back on.
FILLING / RE-FILLING
ADDING LIQUID INHALANT
Pour as much as 1.3 Gallons (4.9
L) or as little as 10 oz (0.3 L) of
water into the fill area located on
the top of the unit.
This humidifier can be used with liquid inhalants such as Kaz Inhalant or Vicks VapoSteam.
Inhalant should be used in the medicine cup only. DO NOT ADD LIQUID INHALANT TO THE WATER.
Step 1: Turn humidifier off, unplug and allow to cool for 20-30 minutes.
Step 2: Add 1 Tablespoon of liquid inhalant to the medicine cup.
Step 3: With dry hands plug unit in and proceed to following unit operating instructions.
Step 4: When no longer using inhalant remove liquid residue left from inhalant by using a soft
dry cloth to wipe out. Note: Liquid will remain in medicine cup even after inhalant
scent has been dispersed into the air.
DO NOT ADD LIQUID INHALANT TO THE WATER.
DO NOT POUR WATER INTO THE BOILING CHAMBER.
Max Fill Line
Pour
Here
DO NOT Pour Here
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honeywell HWM-340 Series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info