661667
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
Position your Hub within 0.5m of your router. Plug the
Power Supply into your mains and connect to your Hub.
The Hub starts up, LEDs flash until only the Power LED remains permanently on. If
this doesn’t happen, check the Power Supply is plugged in and switched on at the
mains.
Connect the Hub to your home router using the Ethernet
cable supplied.
The Network LED should now be lit. If not check that both ends of the Ethernet
cable are plugged in and your router has internet access.
Do not install batteries until you are ready to install the
Cloud Controller. Do not install the Cloud Controller on your
garden tap yet. Remove the front panel from the valve unit.
Install 2x AA 1.5v Lithium/Alkaline batteries into the back of
the front panel. Replace the controller front panel.
When batteries are installed the LEDs will flash until all 3 LEDs go out. The motor
will operate the internal valve. If you have installed flat batteries the ‘10’ LED will
flash red. You will not be able to operate the water timer until the batteries are
replaced with new ones. Replace batteries each season.
Download the App onto your smart phone and follow the
setup instructions in the app to pair the system.
For Apple iPhones the app is available from the Apple iTunes store. For Android
phones the app is available from the Google Play store.
When you have completed the setup in the app install the
Controller on your tap. Check which adaptors are required
to fit the valve unit onto your outdoor tap.
A ½ inch BSP and a ¾ inch BSP thread adaptor are supplied.
With the correct adapters in place, hold the Cloud Controller
up to the tap. Tighten firmly by hand to avoid leaks. Attach
your hose pipe to the hose connector and turn on your tap.
Do not use a spanner or other tool to tighten it up because this could cause damage
to the component threads.
It is important that your water timer is in radio reception
range of the Hub. You can test the signal strength by doing
a Range Test.
Up to 50m depending on obstacles between the Hozelock Hub and the Cloud
Controller. See the troubleshooting section on the Hozelock website for details of
how to do a range test. www.hozelock.com/cloudsupport
You can turn on the water controller at any time by pressing the Water Now
button.
Water now function
Press
Once 10 minutes watering
Press
Twice
30 minutes watering
Press
Three times
60 minutes watering
Press
Four times
Cancels Water Now
The LED light will come on to indicate you have turned the controller on and will
start to flash when the valve has opened. Depending on the mode selected the
lights will count down as the time lapses; So if you press the button 3 times to water
for 60 minutes, after the first 30 minutes the top light will stop flashing and the
bottom two lights will continue to flash.
If you decide to stop manual watering at any time simply press on the Water Now
button until all the green lights stop flashing. You will hear the motor operate the
internal valve turning the water off.
Note: To protect battery life the water controller can only be turned on and off a
maximum of 3 times in one minute.
How do I cancel an automatic watering operation
The button can also be used as a manual override to cancel any current
automatic watering operation that has started. The schedule will then resume.
Battery Level Check (Press And Hold Down The Water Now Button)
3x Green Lights Battery level is Excellent
2x Green Lights Battery level is Good
1x Green Light Battery level is ok but consider replacing them soon
1x Red Light Battery level is low - replace the batteries now
Failure prevention mode
A built in safety feature detects when the battery levels have dropped to a level
that could fail whilst the valve is open and result in wasting water. The safety mode
prevents the controller from turning on until the batteries have been replaced.
The LED indicator light will flash red when the failure prevention mode has been
activated. The Water Now function will also not operate until the batteries have
been replaced.
This product is not designed to be used in sub-zero (frost) temperatures.
During winter months drain any remaining water out of your timer and bring
it indoors until the next watering season.
G½ (½”BSP)
G¾ (¾”BSP)
G1 (1”BSP)
1
GB
Inside your home Outside your home Manual operation (Water Now)
2 3 4 75 6
Inside Outside
Router not supplied
33915-002 CloudControllerInst-UK.indd 2 11/04/2016 12:55
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hozelock 2216 Cloud Controller wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info